...test it. All of the scooter OEM's will tell you the trans-axles are sealed units and if bad have to be replaced. THEIR NUTS, any motor can be rewound, bearing can be replaced. These trans-axles ...
Question about Pride Health & Beauty
...scooter That just stoped working the batteries are new and all the lights work. All I get when I turn it on is a click on the drive motor. All the push fuses are are fine. Please help Have the ...
motor stays dead. Hi roybruce Sounds exactly like a brake problem. To check this run the scooter as far as it will go untill it shuts down or 10 minutes which ever occurs first. Then being careful not
...test instrument until it failed back off on the value until i found it passed. A new battery like the one my scooter uses will put out close to 500 cranking amps. Well when i tested my battery it ...
...scooter wont go. Hear clicking in rear end, assume brake release. Is it possible to test the controller. I have some knowledge of electronics. You can check the voltage going to the motors. The ...
...scooter after a few seconds. got worse over 1 mile now stopped completely. fully charged, batteries test fine. all connections good. replaced controller, speed pot, throttle pot,brushes, batteries as ...
...scooter is now inoperative. Testing reveals that the motor is OK, but it appears that there is a defective component in the CS1008s motor controller board. How does my friend go about getting the ...
...SCOOTER IT HAS BRAND NEW BATTERYS BUT IT RUNS VERY SLOW IT IS ONLY GITTIG 9.3 VOLTS TO THE MOTOR BUT THERE IS 24 VOLTS OF THE BATTERYS I CHECKED ALL THE WIRES THEY ARE GOOD WHAT DO THING I SHOULD ...
Question about Health & Beauty
scooter is immaculate & little used new batteries fitted but will only do about 1 mph with speed pot turned to full thanks Check batteries for volts and load test. if ok it could be the motor brushes ...
getting 4 beeps pause then one beep. Controller is a Curtis 1228-2904 hi,, that means 4,1 CURRENT SENSE FAULT current sense fault 1. Short in motor or in motor wiring. 2. Controller failure. * You can
14 questions posted
Usually answered in minutes!
136 Questions