Jura Capresso Impressa Z5 Espresso/Coffee Maker "tray missing stuck" Questions

...TRAY MISSING it's the contacts at the back so clean as other people have stated, you can also use a cardboard nail file to clean the contacts at the back if there really skanky!. If the machine keeps ...

...missing drawer" light to go off. I've unplugged the unit to allow chip to reset... nothing. I think the elevator is stuck thus causing the drawer to not go in place. I have the same machine and ...

...Tray missing" warning does not go on, I can see the grounds-smoothing levers moving. Might something be caught in the mechanism, keeping these levers from finishing their job? I just fixed it. I saw ...

...TRAY MISSING it's the contacts at the back so clean as other people have stated, you can also use a cardboard nail file to clean the contacts at the back if there really dirty!. If the machine keeps ...

...tray are in as normal. This is enough for the XSmall to startup. Turn the machine on and as it does its self-check, the gears get re-aligned properly. It will eventually figure out the brew group is ...

...missing spacer. * If the handle points to the right shoulder then the gasket is, too thick, too many spacers, or it was installed without removing the old coffee (crud) from the group head and is ...

...missing a rubber seal, o-ring, or washer. Replace the whole tank as a unit. * If your leaking at the bottom, drip tray, or side only when the pump buzzes (pumping water) then there is a cracked or ...