SOURCE: changing the tail light bulbs on a 2000 mazda 626
The Tail Lights Are Accessed From The Inside Of The Trunk There Will Either Be A Panel Immediately Behind Where The Light Is Or Carpet. Remove It And It Will Give You Access To The Rear Of The Bolts Just Grab Twist And Pull And The Light Will Come Out.
SOURCE: Kawasaki vulcan 1500 tail light intermittant problem
well i would try the switch and see and if that doesnt work then check the wiring for a loose connection or ground or maybe it could be as ez as checking the light bulb it might be loose in the socket
SOURCE: process of changing the rear brake pad on the
Remove the 2 break bolts that hold the break to the bracket. Remove the pin covers on the side. <2 flat heads> Remove the Alan key pins and old pads will come out. Use a c clamp and a rag to compress the caliper piston. replace break pads pins and pin covers. Re bolt the break to the bracket. pump breaks till stiff. open bleeder. pump twice and close during pump. clean up and enjoy ;D
SOURCE: Headlight not working...bulb and fuse are good
check fuses first... if ok, buy an electrical tester from walmart for $5 and see if it's getting any electrical to the headlight.. if it is.. replace bulb
It's at least a good starting point.
SOURCE: i need wiring schematics for a 2001 kawasaki
Have 2002 Vulcan 1600 Drifter. The tail and brake lights will not work. They were working rear turn signals do. It blew the fuse twice, now it is not blowing the fuse but still no lights. Got power to the fuse and leaving it not arriving at the rear light. The plug in,before it goes inside the rear fender, what color wires are what so I can check if things are arriving there O.K.?
The
process for replacing tail light bulbs is the same in all models. If
you have a burnt-out tail light bulb, you may need to replace the
brake light, the reverse light or the turn signal. The procedure to
replace each of the bulbs is the same.
Instructions
1.
Open the Hummer's rear swing gate. This will expose the edge of the
vehicle's tail light assembly. You'll see two small Phillips head
screws that hold the tail light assembly in place. Put on your
gloves.
2.
Remove the two screws from the tail light assembly. Pull the tail
light out and inspect the back for two bulbs. The top bulb is the
brake light and turn signal. The bottom bulb is the reverse bulb.
Determine which bulb you need to replace.
4Push
the replacement bulb into its socket firmly. Insert the socket back
into the tail light. Turn it clockwise to secure it in place.
5Place
the tail light into its cradle. Hold it with one hand and replace
the Phillips head screws with the other.
247 views
Usually answered in minutes!
×