Cant get transmission apart from the engine to change the clutch on a 2002 hyundai elantra

If this is 3speed Standard transmission with a clutch, It sounds like you have a worn out clutch, Or the more likely issue the transmission linkage has come apart or worn very badly. Transmission shop may be able to help.

I would say no,has to come apart

FYI, the slave cylinder is pushing correctly, the clutch is the 'PULL TYPE', not the 'PUSH' type.
Go to www.hmaservice.com and register the vehicle by VIN #. You'll then have access to Shop Manuals, Wiring Diagrams, Illustrations, Service Bulletins, etc.

The clutch on the 2002 Elantra, as I mentioned, is the "Pull Type". Instead of 'Pushing' on the throw-out bearing, it "Pulls" on it. The pressure plate engages when the bearing is released (when it is 'pulled' back into the pressure plate 'fingers'

Was the new trans & clutch installed at an authorized Hyundai Service Department? If not, you might want to have them inspect the installation to determine what's wrong. If it WAS installed by a Hyundai Service Dept, take it back to them & tell them to FIX IT!

you need to lift the rear of the engine about 2"then wiggle the transmission while pulling out the idle shaft from the flywheel.in other words keep the trans/engine in a straight line when pulling apart.....

There are 2 possibilities.

1. Since the clutch is hydraulic, some particle is jamming the rod-piston movement, hene the clutch lever is jammed(if using manual transmission)
2. The springs which press the clutch plate to the engine(cam) are either brken off, meaning the clutch remains engaged all the time and since the hydraulics are not able to push them apart(release the clutch)-applicable for auto or manual trensmission.............. ..sodeep

Since you did not say what type of transmission you have i will suspect the clutch is slipping if it's a manual.
If it's an automatic, it could be several things. Low fluid level...clogged filter, fluid needs to be changed..transmission serviced...weak pump, bands/clutch packs worn...etc
Good luck..i hope this helps, please rate me a fixya.

Get your transmission position sensor checked. With it being an automatic it doesnt have a clutch

I don't know if I can help but as an owner of a Hyundai Elantra 2000 GLS with 205,000 miles and the original clutch and transmission I'll try and help!

I always start with the lowest cost solution first and avoid mechanics as much as possible!

Have you checked the trans fluid?
It should be changed every 30,000 miles!
Sometimes a Lucas Trans Fluid will cure - fix slippage!

Have you checked for a clutch adjustmet!
An adjustment can cure - fix slippage!

Are you a clutch rider with your foot always on the clutch?
If so you may have worn out the clutch!

How many miles to you have on your Hyundai Elantra 2000?

Yes, I have that I was just hoping for a few details.

If it is automatic transmission check hydraulic fluid level to be between marks with lever at "P" position, at operating engine temperature and car at horizontal place.