Removing front bumper is easy. Look under the bumper. There are bolts holding it to the frame. Unscrew these and bumper will come of lose. Screw new bumper same way you unscrew the old one. Remember don't titen screws right away. You have to adjust new bamper so visibly floats with fenders and front grill. Than titen up bolts.
SOURCE: I WANT TO REMOVE THE FRONT BUMPER ON MY 2000 HONDA
reach underneath bumper, you will see the post with screws on each post. Just remove the nuts on both sides, and bumper will come off.
SOURCE: what is the firing order on a 2000 4.3 gmc sonoma?
i dont know how they got it....i was just told that they got it......MEN!!!!
SOURCE: Replacing heater core in 2000 GMC sonoma. Dash is
If the dash is removed you've saved about 9 10ths of the job endurance. Look around, what you believe to be, the perimeter of the heater box. I cannot, and no one else can, tell you exactly where the bolts and nuts that mount the heater box are. Therefore you must viually sixe the box and check outide in the engine compartment and inside under the dash for the mounting bolts.You'll want to start by removing the heater hoses. Then starting at the passenger side engine compartment look for a group of 10mm or 7/16ths nuts retaining the housing and remove them. Do the same inside. The housing is usually held together with screws or clips, it changes year to year. Keep a log or pix of the wires and cables and hoses(vacuum) that are connected to the housing for reassembly. You'll need to "roll" the box out from under the dash depending on how much of the dash has been removed. The core is easy to spot for is has two hoses sticking out, and, is encircled with clips or screws . Also make sure you remove the bracket around the two entry hoses if it has one. Thank you, Dana
SOURCE: front axle is not engaging when put i 4wd,2000 gmc
is the front tail shaft turning,if not problem is in transfer case
SOURCE: how do i remove and install and new u-joint on a
Most chevys require to remove the driveshaft from the truck and make sure the truck won't roll as the drive shaft holds the truck in park with the shaft out this won't happen. once the shaft is out the U-Jounts are heald in with plastic that has to be heated with a torch to get the plastic to melt out. once the plastic is melted out the u-Joint can be pressed out with a press or a ball joint press that can be rented at an auto prts stroe the other answer is to take the shaft to a machine shop and have them do the pressing and give you back the repaired shatf.
477 views
Usually answered in minutes!
×