Remove the cap from the fluid reservoir - fill the reservoir to the full mark.
Start the engine and slowly turn the steering wheel full lock left then full lock right. Repeat a few times. Then check the fluid level again.
Turning the steering wheel full lock should allow the fluid to get throughout the system. Any air in the system should vent to atmosphere from the reservoir.
SOURCE: how do i bleed air from power steering pump from
Vehicle cold. Power Steering pump full to the Cold mark. Power Steering cap on. Start the vehicle, turn the wheels hard left, (When it touches the wheel stop, and you hear a groan, don't hold it there!), then turn the wheels hard right. Do this a number of times. 6 to 7.
Vehicle off. Wait two minutes, then check the fluid level. Reinstall the cap, drive the vehicle around.
Sometimes it's real hard to get the air out. I have had some vehicles that I did the above, then had to let them sit overnight. The next morning I drove the vehicle again, and finally all the air was worked out.
SOURCE: "when do i change the cam belt on a peugeot 307 sw diesel"
usually you should do it for peugeot diesel at 122000 miles along with water pump and the tensioner roller that runs under the cambelt too. But to be on the safe side do it at 100000 and save the fortune.
It took me (DIY job) about 6-8 hours as i wanted to save 450 pounds.
SOURCE: power steering pump Ford Focus 2006 DIY Manual
its quite quite simple;take your pipes of and block them off reconnect them to new pump and replace pump to in line belts.adrian;;;
SOURCE: no power steering on 307 2003 replaced poer
make sure you bleed it well lock steering left and right and hold to make sure all pipe are full pf fluid and top up power steering
798 views
Usually answered in minutes!
×