Ive checked the fuses and they are fine the switch i'm pretty sure is what is bad on it (it just moves up and down freely) but i was wondering if there was any wiring schematics out there so i can just wire up a switch and put it in the dash
Hi. Thanks for your question. For any issues related to wiper switch you can visit https://www.reliable-store.com and download the entire workshop manual which includes all the information along with the diagrams for better understanding. Good day!
Repetitive referrals to fraudulent site
×
SOURCE: lost dash lights and running lights
Check your lamp out senser,and if you have a trailer wire package, disconect it. if the problemn goes away do not hook up trailer wiring again. If lights do not work and you have looked at all fuses,under hood and in the passenger compartment with a test light have your lamp out sensor checked.
SOURCE: Lost lights
hi as you have checked all fuses for these light ok? and other lights are all working may i suggest you check the relay for side/tail lights which also includes licence plate light first it sound like the relay has failed if you look under fuse/relay cover you may find map indicating location? i would try this first b4 switch hope this helps?
SOURCE: Rear wiper motor not working
most likely the wiper motor is bad the second wire sould be a ground if you set meter to ohms you sould be able to get a low resistance to any good ground on the vehicle if the hot wire is hot any time key is on the bcm is controling the ground to operate moter and you should have a steady continuity on the ground side with switch on the fast postion an it will read on and off in the intermitant postion if both wires test good motor is bad when you replace motor let it cycle and shut it off before installing the arm on it
SOURCE: power windows won t work
There are broken wires in the wiring harness between the frame and your driver's side door. These wires control all the windows and door locks in a 95 Jeep. Same thing happened to me. You will have to cut the rubber boot to get it off and check which wires are broken and repair them.
SOURCE: no low beams toyota tercel
This could be caused from bad dimer switch/ lost ground for high beams / or is it possible both of your high beams are bad? have you used a test light at the light to verify no power and good ground?
Testimonial: "good advice "
89 views
Usually answered in minutes!
×