New sensors cam and crankshaft. All new timing parts All of them... car runs great but have code p00116 thanks for any help Ed
You got a bit carried away with the code
code p 0016 refers to crank shaft position/cam shaft position sensor, bank 1 sensor A---correlation === causes --wiring---CKP sensor --CMP sensor ---mechanical fault
code p 0011 refers to cam shaft (CMP) intake /left /front bank 1 --timing over advanced / system performance==== causes ---valve timing---engine mechanical fault --- CMP actuator ---wiring
you didn't mention the fault so consider this
if the timing is out on the intake cam shaft , it will idle good but play up as the timing actuator moves it further advanced with rpm
if the actuator is not wire properly or the solenoid is faulty , then the inlet will lag with increased rpm and again cause you problems
It is doubtful if the position sensors for either the crank or cam shafts are a problem because it starts and idles good
Testimonial: "Thank you. What would you suggest for a fix?"
SOURCE: timing chain tensioner
I have a '94 Altima with 2.4 liter 4 cyl. engine. At around 150K the timing chain and tensioner were replaced - should solve your problem, too. If you're sure the chain is rattling you should really get it serviced now, not later. Also, if your car is running rough it could be more than just the chain and tensioner; it could be your ignition system, such as plugs, coil, distributor, etc. Bottom line is, your car needs to be checked out right away.
SOURCE: chrysler 300m 2001 starts after unplugging cam sensor
theres a reflash program that needs to be done on these cars, because of extended crank time and cam / crank syhcronizing out, start there,also i had one with same code and found that aftermarket cam sensors dont work, installed dealer part and had the updated reflashing done and solved the problem.
SOURCE: replace satellite system in 2007 saturn aura xr
If you are looking to convert your radio from XM to Sirius, there are a number of kits available by typing 'convert radio from XM to Sirius' into your favorite search engine. But why bother? XM and Sirius have merged and you can now get Sirius programming on the XM band.
SOURCE: 2009 Saturn Aura xr. At very low speed (under 5
I believe your transmission is slipping. Contact an authorized Saturn service center to have this evaluated.
SOURCE: How do you change a
locate the crankshaft sensor, disconnect electrical plug, make sure around sensor is clean so grit etc doesn't fall in when sensor is out, unscrew with appropriate spanner, replace with the new sensor and reconnect plug. may also need some thread tape on thread before screwing in.
Testimonial: "Thank you, I guess I should of asked where is it located? But it sounds easy enough."
254 views
Usually answered in minutes!
×