I need a picture where the knock sensor is on a 2001 toyota tundra 4.7

Question edited for clarity.
Question moved to model category.

2006 Toyota tundra 4.7L Front End Torque Specs

toyota-specs.com https://toyota-specs.com > cars > 2006 > tundra4.7 > t...
Toyota Tundra Front Axle Nut Torque Spec : 203 ft-lbs · Toyota Tundra Wheel Hub Torque Spec : 100 ft-lbs ...

BHA53102 Axle / Spindle Nut Torque Specification

1A Auto https://docs.1aauto.com > BHA53102 Torque S... PDF Toyota. 4Runner. 1996-02 4 Wheel Drive. Front. 174. 236. Toyota. Sequoia ... Tacoma. 2001-04 4 Wheel Drive. Front. 173. 235. Toyota. Tundra. 2000-06 4 Wheel ...
1 page
https://www.google.com/search?q=2006+Toyota+Tundra+4x4+front+axle+torque

..

try here
https://workshop-manuals.com/toyota/

IT IS ONLY NECESSARY TO POST YOUR QUESTION ONCE, AND IT HELPS IMMENSELY IF YOU ASK AN ACTUAL QUESTION! SHEESH! How many times did you post the same badly-worded vague statement, anyway?

PUT A 4.7 OUT OF A 2001 TUNDRA IN A2000 BODY USED 2000 COMPUTER ENGINE RUNS GREAT BUT NO THROUDLE RESPONCE CHANGED POSITION SENSOR SAME THING

The left (drivers) side cylinder head is numbered from front (radiator)
1-3-5-7

The right (passenger) side cylinder head is numbered from front
2-4-6-8

per 2001 Toyota repair manual page EM-103 and 105. The numbers are not on the engine, from what I can see, but the manual is very specific on this info.
2001 Toyota Tundra Access Cab SR5 2WD
4.7 liter DOHC V-8 (2UZ-FE) 2001 Toyota Tundra Access Cab SR5 2WD
3.4 liter DOHC V-6 (5VZ-FE)
http://autorepair.about.com/library/firing_orders/bl-toyota-firing-01.htm

P0333 - Knock Sensor 2 Circuit High Input Bank 2. The knock sensor is attached to the cylinder block. It senses engine knocking using a piezoelectric element. A knocking vibration from the cylinder block is sensed as vibrational pressure. This pressure is converted into a voltage signal and sent to the Powertrain Control Module or Electronic Control Module.

The code is triggered by an excessively high voltage from the sensor is sent to Powertrain Control Module or Electronic Control Module.

Possible Causes:
- Knock sensor circuit short to GND.
- Knock sensor circuit short to PWR.
- Knock sensor circuit open.
- Damaged knock sensor.
- Powertrain Control Module

Possible Solutions:
- Repair or resecure harness or connector
- Replaced knock sensor

should be on thermostat housingtwo wires

Drivers side is bank 1, sensor 1 is found by looking up from under the truck on the exhaust pipe just below the manifold.