SOURCE: 2007 Dodge Nitro Tail Light Replacement
look at the car manual under maintenance and then rear light bulb replacement. First take out the two hole covers using a flat head to loosen then wiggle and turn by hand to get out. Pull the light unit straight back, and unplug the electrical. Don't break anything.
Then use a star driver (check your misc socket set drivers for the right size). Unscrew the two star head screws and pull this bulb holder straight off the tail light (same direction as screws). Replace the bulb and put back together in reverse.
SOURCE: I need a serpentine Belt diagram for a 2007 Dodge
This link should help you. Also you vehicle came from the factory with a diagram under the hood somewhere.
http://www.aa1car.com/library/serpentine_belt.htm
SOURCE: 2008 dodge nitro change oil light how to turn off ...
Directions are in the book, but you would put the key in and turn it all the way, just don't start engine. Pump gas pedal all the way to the floor 3 times slowly, but it has to be with 10 seconds. Turn key off and when you start again, oil changed chime and warning should not be on. If it is, try again.
SOURCE: i need a photo for
Check this image...
Serpentine belt routing 3.7
Hope helps (remember to rate this answer).
56 views
Usually answered in minutes!
Most likely you have blown out all the electronics
×