What does Throttle control/Transmission fault on a 2010 Ford Fusion

SOURCE: Electronic Throttle control light came on and car died

We ended up taking the vehicle to a trusted auto repair shop. The codes came up indicating a failed throttle body, most likely in the electronics. After a few more pinpoint tests, the recommendation was to replace the throttle body. The cost for this repair was just under $500. Since there is no aftermarket on this part, Genuine Ford parts were used.

SOURCE: No transmission fluid Dipstick on my 2007 Ford Fusion

depending on which trans it is there is a small dipstick on the trans at the front on the bottom these transmissions take a specific fluid so be careful

SOURCE: Ford Fusion 04 Engine Management Light

I had a 2002 model 1.4 Fiesta, same problem Engine management light or ECA, electronic accelaration Control (EAC), it needs a ford dealer to do a computer diagnostic, most likely that it will need replaced.

Mt friend who is a mechanic for ford said that it was a common factory fault and is very common in 1.4 zetec /duratec petrol models.

I now have a 2007 Fusion and was quick to see if this problem had been sorted on this model, and it has!!

Hope this helps!!

SOURCE: EAC FAIL FORD FUSION 03

I have an EAC failure on my wifes 53 reg Fusion 1.4 and it's been off the road for 2 months. An independent check showed fault code P2135, which relates to the throttle body but fitting a body from a healthy Fiesta with the same engine didn't solve the problem. I was advised to check wiring to the body but all seemed OK. Took car to Ford who stated that the car needs an updated body and wiring and the parts are on back order with first delivery not due until Jan 2010! Why the car won't work with replacement original parts is a mystery. I'm very disappointed with Ford. Sorry this doesn't solve the problem but hope it clarifies the situation. Have logged this on other websites and with BBC Watchdog!

SOURCE: throttle does not work-wrench light on

I need to know if the TPS in my 2006 Ford Fusion SEL, can be replaced on my own, or does it need to go to a dealer to be replaced?