How to turn off maint requred light - 1992 Plymouth Voyager

2006-2015 Toyota Highlander MAINT REQD Light Reset

seventrumpet.com/2006-2015-toyota-highlander-maint-reqd-light-reset/
Mar 15, 2015 - How to MAINT REQD Light Reset on Toyota Highlander 2006, 2007, ...Turn the ignition switch to the "On" position, but do not start the engine ... This procedure should applies to the second and third generation of the Toyota Highlander (2005, 2006, 2007, 2008, ... Your email address will not be published.

Hold "trip reset" , turn ignition key to the "on" position and continue to hold, it will start flashing after 10 seconds , continue to hold until it stops. Release "trip", turn key off then on and recheck .

The '91 & newer models turned the maint, req. light on by a timer in the ECU & the ECU turns it on around 120k miles based on a timer and requires a dealer or shop visit to be reset.But it isnt going to hurt anything by being on.

When a Honda Maint Req light blinks, but then stops, it is telling you to change your oil. If you don't change it, eventually, the maint req light will stay on. Here is how you reset the maint req light: 1) Turn they key to the II position
2) Turn the key to the off position, and push and hold in the odometer reset button
3) Turn they key back to the II position, while still holding the odometer button.
4) After about 10-15 seconds, the light should go off.
If that doesn't work, try it this way: p.p1 {margin: 0.0px 0.0px 0.0px 0.0px; font: 12.0px Verdana}

With the igniition off, press and hold the odometer button, turn the key to the "on" position, but do not start the car. Keep the odometer button down until the oil light begins and ends flashing. Turn the key off, and then start car to see if it worked or not.

Maintance light should have nothing to do with car dying out. These cars are having problems with crankshaft and camshaft position sensors. It cause the computer to lose signal of how fast engine is turning and it will die out.

Reset the "MAINT REQD" Light on Toyota Sienna:

1. With the car started (ignition on), set the LCD odometer readout to total mileage (not trip A or B).
2. Turn the car off (ignition key to the OFF position).
3. Push in AND HOLD the button/knob that switches the odometer
4. Turn key to ON position without starting the car. You will notice the maintenance light blink and go out.
5. Release the odometer button/knob.
6. Turn key to OFF position.
7. That's it! The "MAINT REQD" light has been reset to warn you to change your oil in another 5,000 or 7,500 miles or so.

Hope helped with this (remember rated this help) Good luck.

LOOK IN THE OWNERS MANUAL

watch this free video instructions on how to reset your maint reqd light if video dosent work go to www.vehix411.com

you need to hold down the reset button with one hand while you turn the key on, you will see the 5 lines count down

hello frcs68 , to reset the light , turn key off , press and hold the trip meter knob , turn the key to on , engine off , continue to hold it till it flashes , - - - - - , - - - - . - - - , - - , - , - - - - - , it looks like that , then its reset . hope that fix ya