SOURCE: torque specs needed
do you have a Haynes reapir manual or Chiltons? if not you can get one from autozone or some other parts places, or you might find one in your local library, inside that book are all the torque specs you can stand.
SOURCE: 1994 CHRYSLER LHS. CHANGED PLUGS, CHANGED WIRES,
if you have fuel look at crank ,cam, map,tps, sensors
SOURCE: What are the torque specs for a 1992 Chrysler
6 ft/lbs
Testimonial: "The information that was provided to me was excellent. i would have been lost without it. Thanks"
SOURCE: need the torque specs for
Fig. Intake manifold bolt torque sequence 2.7L engine
Upper intake manifold with a new gasket on the lower intake
manifold and torque the bolts, in sequence, to: 105 inch lbs. (12 Nm)
Hope helps (remember to rate this answer). Good job.
SOURCE: 2001 chrysler voyager just replaced
for the head Step 1: Bolts 1 - 8 to 61 N·m (45 ft. lbs.) † Step 2: Bolts 1 - 8 to 88 N·m (65 ft. lbs.) † Step 3: Bolts 1 - 8 (again) to 88 N·m (65 ft. lbs.) † Step 4: Bolts 1 - 8 turn an additional 1/4 Turn. (Do not use a torque wrench for this step.) NOTE: Bolt torque after 1/4 turn should be over 122 Intake Manifold Bolts . . . . . . . . . . . . . . . . . . . .23 N·m (200 in. lbs.) Intake Manifold Gasket Retaining Screws . . . . . . . . . . . . . . . . . .12 N·m (105 in. lbs.) Intake Manifold Plenum
N·m (90 ft. lbs.). If not, replace the bolt.
Bolts . . . . . . . . . . . . . . . . . . . .28 N·m (250 in. lbs.)
the pivot arm ? whats that
Fig. Intake manifold bolt torque sequence 2.7L engine
Upper intake manifold with a new gasket on the lower intake
manifold and torque the bolts, in sequence, to: 105 inch lbs. (12 Nm)
Hope helps (remember to rate this answer). Good job.
58 views
Usually answered in minutes!
×