SOURCE: Chaning right wheel bearing on 1999 Chevy Malibu
It is much easier, and cheaper to find a steering knuckle or "hub assembly" in a salvage yard.
To begin, jack up the car and remove the wheel. Be certain the car is stable and will not roll off jack(s)!
Remove the spindle nut. Remove the brake caliper (hang on a wire).
Remove the bolt for lower ball join. Remove the bolt that goes thru
strut. Now, pull assembly off while prying to ease pressure from the
lower control arm.
Depending on how many miles you have on the car, you might want
to head-off some future trouble by replacing the half-axle while you
have the front end disassembled.
SOURCE: 1999 mercury sable front wheel bearing
Not too bad. Just remove the Wheel and the Brake Calipers. Then remove the Dust Cap off the Center of the Rotor. Inside there is a Bolt with a Cotter Pin In it. Remove the Cotter Pin and the Bolt. The Rotor will now Slide off the Spindle, The Bearings are Loose and Probably inside the Rotor. Remove these Bearings and get a Tube of High Temp Grease. Put a Big gobb of grease in the Palm of your hand and Roll the Bearing around in your Hand. Be sure to use your Fingers on the Inside of the Bearings to get it in. The same Goes with New Bearings.
SOURCE: 1999 Chevy S10 Blazer 4x4. Replacing rear pad's,& Bleeding Breaks
have one person in the blazer pumping the brake pedal and then hold to the floor, crack the bleeder then tighten, release pedal, repeat till all air is out one side at a time, if this does not work then your ABS unit is bad witch if u follow your lines from your master cylinder u will find a black box with a motor on it, or the master cylinder itself is bad, it also can cause u to have no pedal, replace the master cylinder first, most likely cheaper.
SOURCE: how do i replace the rear wheel bearing on my peugeot 206
wheel off remove the tin cap in the centure of the hub undo the big nut put the wheel back on with just 2 bolts finger tight so you can pull the hub off.once the hub is off take the 2 wheel bolts back out.now look in side the hub were the big nut was and you will see a sir clip take that out.then use a socket and a bench vice to press the old bearing out.use the socket and bench vice to put the new bearing back in.
SOURCE: replace rear wheel bearing 2002 ford explorer 4x4
you must remove brakes, then remove axle nut, then remove upper control arm and finally tie rod stabilizer, remove axle from car then bearing can be accessed. this is a difficult job that requires special tools so be careful
198 views
Usually answered in minutes!
×