SOURCE: Where is the starter located on a 1993 mercury sable engine
trace the big cable that came from the positive terminal of your battery. at it's end is the starter.
or if it passes trough a big relay, then there is another big cable from that relay that would go down to the side of the engine, either left or right, that would be the starter.
tnx 4 using fixya,
drcool
SOURCE: 2000 Mercury Sable 24V 3.o engine. Need to know
yes about the upper intake and the only way i know how to check the coils is with a engine anilyser or if the check engine light comes on then you can have the codes pulled and that will tell you which cylender is missfiring this engine has a indevidual coil for each spark plug so thares 6 of them and thay slide right down over the sparkplugs
SOURCE: how to remove starter from 1993 mercury sable
Disconnect the battery cables. Locate the starter and disconnect the wiring. Next remove the mounting bolts. You may then remove the old starter. All this sounds easy, and it is, the only difficult part is accessing the starter. It is not easy to get to the bolts and you will likey have to do some feeling around and knuckle busting. But be patient, take your time and you should be able to pull off this repair. Good luck. I hope you find this to be very helpful.
SOURCE: fuel pump relay location on 98 mercury sable
its under the hood on driver side what the problem not starting check the trunk area for the fuel cut off switch poss bad or tripped did u get hit or someone bump ur car
SOURCE: no diagram for 1999 mercury sable for serpentine
Click on the following free direct Link.
It has the correct Belt Diagrams for your 1999 Mercury Sable 3.0L V6.
Let me know if this helped, or if you have additional information questions. Feel Free to contact me at FixYa.com!
http://www.2carpros.com/car_repair_information/year/1999/make/mercury/model/sable/1999_mercury_sable_drive_belt_routing_diagram.htm
USING THE ANALOG VOLTMETER
See Figures 3 and 4
Service codes will be represented by pulsing or sweeping movements of the voltmeter's needle across the dial face of the voltmeter. Therefore, a single digit number of 3 will be reported by 3 needle sweeps. However, a service code is represented by a 2-digit or 3-digit number, such as 23. As a result, the Self-Test service code of 23 will appear on the voltmeter as 2 needle sweeps, then after a 2 second pause, the needle will sweep 3 times.
Connect the analog voltmeter as follows:
Fig. Fig. 3: Voltmeter hook-up
Fig. Fig. 4: Analog voltmeter output code format
USING THE MALFUNCTION INDICATOR LIGHT (MIL)
During the Self-Test,a service code is reported by the malfunction indicator light. It will represent itself as a flash on the CHECK ENGINE or SERVICE ENGINE SOON light on the dash panel. A single digit number of 3 will be reported by 3 flashes. However, a service code is represented by a 2-digit or 3-digit number, such as 23. As a result, the Self-Test service code of 23 will appear on the MIL light as 2 flashes, then, after a 2 second pause, the light will flash 3 times.
183 views
Usually answered in minutes!
×