SOURCE: 2001 pontiac sunfire serpentine belt diagram
go to autozone.com and it will give you the belt diagram
SOURCE: how to replace a serpentine belt on a 2004
SOURCE: how do i change a serpentine belt for a 2007
Drive Belt: Service and Repair
DRIVE BELT
Components
REMOVAL
1. REMOVE V-BANK COVER SUB-ASSEMBLY
2. REMOVE NO. 1 ENGINE UNDER COVER
3. REMOVE FAN AND GENERATOR V BELT
(a) While turning the belt tensioner counterclockwise, align the service hole for the belt tensioner and the belt tensioner fixing position, and
then insert a bar of [diameter]5 mm (0.197 in.) into the service hole to fix the belt tensioner in place.
HINT: The pulley bolt for the belt tensioner has a left-hand thread.
(b) Remove the V belt.
1. INSTALL FAN AND GENERATOR V BELT
(a) Set the V belt onto every part.
(b) While turning the belt tensioner counterclockwise, remove the pin.
NOTICE: Make sure that the V belt is properly set to each pulley.
(c) After installing the belt, check that it fits properly in the ribbed grooves.
HINT: Make sure to check by hand that the belt has not slipped out of the grooves on the bottom of the pulley.
2. INSTALL NO. 1 ENGINE UNDER COVER
3. INSTALL V-BANK COVER SUB-ASSEMBLY
SOURCE: 2007 chrysler sebring serpentine belt diagram
Go to; daycoproducts.com, click cars and trucks, then go to serpentine belt. Then on the right side of the screen click on finding your vehicle. Then get the illistration number and click on illistrations, go to that number it should something 6-? or 7-?. It's a pretty good websight.
SOURCE: How to clean O2 sensor on a 2007 Pontiac G6?
O2 sensor are located before and after Catalytic Converter ( exhaust system of your car). If you car's engine is 4 cyl you have 2 O2 sensors and if you car's engine is 6 cyl then you have 4 O2 sensors ( for each bank, 2 for left bank and 2 for right bank). Hope it helps and comment if you need more advice. Please don't forget to rate the answer it helps with my ratings, thanks!
1,719 views
Usually answered in minutes!
×