It on the flywheel in front of the engine where you would look for timing mark.
SOURCE: location of speed sensor a for 99 dodge intrepid
The "Vehicle Speed Sensor" signal is generated by the transmisson output speed sensor. That is the one located at the rear of the case. It is externally mounted. That supplies "vehicle speed" info to the other On-Board Computers. The input turbine speed sensor is located just behind the bell housing area of the case. I believe the trans controller is the only module that needs that info. The Crank Position Sensor give engine RPM info and it is located on the bell housing near the engine block. I hope this helps.
SOURCE: Dodge Durango 1998 5.2L Output Speed Sensor code P0720 Location
Its in different locations depending on if its 2wd or 4wd. For 2wd its in front of the drice shaft or for 4wd its in the tranfer case, just look for a white shape like box with wires plugged into it and you need a socket to remove it, iam not sure how much it is to replace as the cost varies at different shops.
SOURCE: I need the location of MAF sensor in a 1998 Dodge
Your vehicle dose not have a maf sensor. They used a map sensor it is on the engine located under the front of the breater where it attaches to the engine.
SOURCE: 2002 pt cruiser codes p0725 engine speed sensor
i have this same problem with my pt cruiser did you ever figure out what was wrong with it
thanks let me know my email is [email protected]
38 views
Usually answered in minutes!
×