Abs traction control lights

The light being on means the system has detected a problem in one or more sensors. The vibration is the ABS modulating the brakes to prevent skidding because it has detected a wheel that is locked up. That wheel is most likely the one sensor that is giving you the error.

Whenever this warning or any other stays on in the dash it is indicating that the systems control module has detected a fault, it then disables the system as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

have the code pulled from the computer to find out what set the lights on.the traction control works off of the abs sytem and so if theres a problem its not uncommone for both lights to come on.the brake light and abs lights on at the same time means there is a possible serious problem

I would open with a visit to a transmission shop. on a car that old you are looking at a rebuild which may well cost more than the car is worth. things, just like people, wear out and break down with age and use. after the transmission is rebuilt you are going to need an engine diagnostic to find out what is making the service engine light stay on. In the olden days cars just broke down with no warning, the silly thought behind the warning lights was that folks would get the cars seen to if they had advance warning of a coming failure. however the sad truth is that the lights just stay on warning of failure until the failure ad then the owner wonders why.

Traction control and anti-locks(ABS) lights come on there is sensors that are pluged in behind the rotors check and see if they are disconected or loose sometimes when you change your brake pads they might come loose and not making contact.

Could have a ABS wheel speed sensor going bad, once this happens will disable the ABS and the trac control. Have it scanned and find out which sensor is bad. Small possibility of ABS module failure, but not as likely.

The taction light generally lights when you have an ABS fault. This is very rational because you don't want the traction control trying to kick in if the ABS is off line. Check your fuses first. If all good bring it to a qualified shop. DON'T mess with barkes unless you know whatyuo are doing

SteveD

make sure u didnt break a wire, there are sensors on the brakes, make sure theyre plugged in

service engine soon is a mere fuel problem....make sure youre putting premium fuel only in your tank...throw a hand held code reader on it and I would bet you money its fuel related..usually nothing at all to worry about...the code reader can also turn off the light for you

Sounds like they may have left something disconnected like the ABS/ Traction control wheel sensor, make them fix it!!