1996 Toyota Camry Logo

Related Topics:

A
Anonymous Posted on Aug 17, 2012

Location toyota tacoma 98 open circuit relay - 1996 Toyota Camry

5 Related Answers

Anonymous

  • 6 Answers
  • Posted on Nov 05, 2008

SOURCE: no power to fuel pump. I have power up to the circuit opening relay.

I am not positive how the electronics are routed on a later model truck but I had this same problem on my 89' with a 22re. It turned out that the oil pressure sending unit was in the fuel pump circuit so as to not allow the engine to start with no oil pressure. I changed my sending unit and the truck fired right off. Hope this helps.

Ad

Anonymous

  • 4 Answers
  • Posted on Jun 05, 2009

SOURCE: How do you change the spark plugs on a 2007 Toyota Tacoma?

bring it to a garage

Anonymous

  • 273 Answers
  • Posted on Jun 06, 2009

SOURCE: Fuel Filter, 2002 Toyota Tacoma

follow your fuel lines back from the injectors/carb it is a cylinder shapped unit should be at the top of the engine near the windscreen

Anonymous

  • 426 Answers
  • Posted on Aug 26, 2009

SOURCE: Where is expansion valve located on 98 toyota

The expansion valve is located inside the evaporator box. the book gives you about 1.4 hours to change it but if your not sure about working on ac systems I would recommend using a licensed repair facility.

Anonymous

  • 241 Answers
  • Posted on Sep 25, 2009

SOURCE: my 08 toyota tacoma tailgate latch is jammed and

Some gravel has gone down the latch holes on each side. Take the tailgate out and place it on something that won't scratch it like an old blanket. Turn it upside down each way and gently tape on it with your hand to dislodge the gravel while operating the latch.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Where is the fuel pump relay located on a 1996 Toyota Tacoma

Open the hood and look for the engine control fuse box. On the inside of lid it should tell you which one is the fuel pump relay.
0helpful
1answer

Toyota Tacoma fuel problem

Check the following:
- Listen to the fuel pump noise under the fuel tank.
- Starter signal.
- EFI relay, under the hood fuse and relay box.
- Fuel pump operation and pressure.
- Regulating valve.
- Circuit Opening Relay (COR) under the dash.
- Check for open in harness and connector between circuit opening relay and fuel pump, and fuel pump and body ground

83744154-13d8-40aa-bba8-aac743062e3f.png
98828e43-1df3-476c-94fa-036164d23c8e.png

2e76aaa2-2dec-411f-a493-b4d0f142f0f8.png
Hope that works. Thank you for visiting Fixya.
1helpful
1answer

Where is the decelaration senser for the a.b.s. o4 tacoma 4x4

Diagnostic Test Code (DTC) C1244 is a "maufacturer-specific" code used by Toyota for this vehicle. Toyta defines this code simply as "DECELERATION SENSOR CIRCUIT."

Possible causes are:
> Faulty ABS deceleration sensor
> Open or short in deceleration sensor circuit
> Defective wiring harness or connectors

The deceleration sensor for your 2004 Toyota Tacoma is located under the passenger seat.
0helpful
1answer

1997 Toyota Tacoma 4 WD 4 cyl. Where is the fuel pump relay.

It should be under the driver's dash to the left of the steering column. The Haynes manual recommends you first remove the lower finish panel on that side for access. Haynes calls the fuel pump relay the "circuit opening relay."
7helpful
2answers

Have p0130 and p0133 codes 98 toyota tacoma

check the mass air flow sensor there maybe dirt on the filiment inside the sensor causing false readings. cleaning or replacing it may make the codes go away.
3helpful
1answer

Where is expansion valve located on 98 toyota tacoma

The expansion valve is located inside the evaporator box. the book gives you about 1.4 hours to change it but if your not sure about working on ac systems I would recommend using a licensed repair facility.
1helpful
1answer

I have a 99 tacoma with no power to fuel pump,fuses are good, power to relay and have swapped relays, but I don't have any power to the fuel pump. Is there some type of inertia switch?

Look to see if you have power at pin 1 of the circuit opening relay. The C.O. Relay is what powers the fuel pump. If you have power there (a blue wire), you have an open circuit between the relay and the pump.
0helpful
1answer

95 tacoma turn siginal/ flash relay

http://www.tacomaterritory.com/forum/ ,,,,search online repair manuals
0helpful
1answer

No power to fuel pump. I have power up to the circuit opening relay.

I am not positive how the electronics are routed on a later model truck but I had this same problem on my 89' with a 22re. It turned out that the oil pressure sending unit was in the fuel pump circuit so as to not allow the engine to start with no oil pressure. I changed my sending unit and the truck fired right off. Hope this helps.
Not finding what you are looking for?

214 views

Ask a Question

Usually answered in minutes!

Top Toyota Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

926 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...