20 Most Recent 1996 Toyota Tacoma Questions & Answers


Firing order should be 1 3 4 2 firing order-undefined-undefined-0_3.jpg

1996 Toyota... • Answered on May 04, 2021


An engine needs 3 things to run, Spark, Fuel, & Compression. If you have verified that you have spark at the plugs, and fuel is making it into the cylinder, and the engine has the proper amount of compression to run... these also have to happen in the correct time. Make sure your timing marks all line up.

1996 Toyota... • Answered on Jan 16, 2019


The wiring for the CKS may be bad, weak or broken .

1996 Toyota... • Answered on Jan 01, 2018


Not sure what itnighters are, sorry. You seem to be describing a flat spot - a hesitation during initial acceleration that is commonly caused by either insufficient spark power or the fuel system being slow to adjust to the new requirements. A backfire is an explosion in the exhaust system and I wonder if you really meant a spit-back (through the intake), which is common with a fuelling caused flat spot? Replacing the spark plugs is merely half the job and testing the spark power is the other half... I suggest you check the fuel pressures and pressure regulator function and the injector spray patterns. Only if all tests good it could be worth testing the oxygen sensor...

1996 Toyota... • Answered on Oct 04, 2017


just replace the oxygen senser

1996 Toyota... • Answered on Jun 07, 2017


any charge port will evac the system the compressor will not be running adding oil is not necessary as there is enough in the replacement compressor run the vacuum pump for a couple of hours and then lock of the system to see it it holds vacuum

1996 Toyota... • Answered on May 07, 2017


if power to fuel pump --was pump tested for short or proper operation --sounds like the pump is gone according to description and testing that was done

1996 Toyota... • Answered on Apr 18, 2017


Under vehicle, passenger side, below seating area, front of catalytic converter, mounted in exhaust pipe Application: Number one Buy what they call a special long socket made for removing oxygen sensors. It it only around 10 bucks and well worth it.

1996 Toyota... • Answered on Feb 14, 2017


If you are absolutely certain that the battery is ok and charged, check the cables for tightness and corrosion - particularly the black earth cable where it attaches to the engine block/bodywork. Undo the bolts slightly and retighten .. Before you try anything, can you get a neighbour or friend to boost start/jump start your car? If it starts ok .. that tells you the starter motor is ok .. and the problem lies with your battery/leads

1996 Toyota... • Answered on May 12, 2016


Have to make sure battery has a full charge and battery connections good. How long since a tune-up? Are there any applicable trouble codes? If the starter motor won't crank, have to check starter wiring circuits. Usually two voltage circuits at the starter motor. One is battery voltage, hot all the time. The other circuit usually goes hot with the key in the crank position and may be wired through a relay and clutch or neutral switch, depending on the tranny. The ground for the starter motor is usually through the engine block. Any testing, make sure tranny is in park or neutral and functional parking brake is set. Safety is your responsibility when working on a vehicle.

1996 Toyota... • Answered on May 12, 2016

Not finding what you are looking for?
1996 Toyota Tacoma Logo

522 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Toyota Experts

Thomas Perkins
Thomas Perkins

Level 3 Expert

14869 Answers

Greg Bernett
Greg Bernett

Level 3 Expert

2993 Answers

Mike

Level 3 Expert

4376 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Tacoma Toyota

  • Tacoma Toyota

Most Popular Question

coolant leak from engine warmer

  • Cars & Trucks
Loading...