I was coming home from work and the tranmission started slipping andnow it dont want to move no more it has a code PO720 OUTPUT SPEED SENSOR CIRCUIT
SOURCE: 2007 FORD EXPLORER SPORT TRAC 4X4 Change oil light on
Press and hold the SELECT/RESET
control switch to select SYSTEM
CHECK when “SYSTEM CHECK /
HOLD RESET” is displayed in the
message center. Selecting this
function from the SETUP MENU
causes the message center to cycle through each of the systems being
monitored. For each of the monitored systems, the message center will
indicate either an OK message or a warning message for two seconds.
Pressing the SELECT/RESET control switch cycles the message center
through each of the systems being monitored.
The sequence of the system check report and how it appears in the
message center is as follows:
1. OIL LIFE RESET
2. CHARGING SYSTEM
3. WASHER FLUID
4. DOOR AJAR
5. EXTERIOR LAMP
6. BRAKE SYSTEM
7. PARK BRAKE
8. MILES TO EMPTY
9. FUEL LEVEL LOW (will only display if 50 miles or less to empty)
To reset the oil monitoring system to 100% after each oil change
[approximately 5,000 miles (8,000 km) or 180 days] perform the
following:
1. Enter SYSTEM CHECK to display
“OIL XXX% RESET IF NEW”.
2. Press SELECT/RESET control
switch to display “HOLD RESET IF
NEW OIL”.
3. Press and hold the
SELECT/RESET control switch for
more than 2 seconds. Oil life is set
to 100% and “OIL CHANGE SET TO
100%” is displayed.
SOURCE: P2195 CODE ON 2003 FORD EXPLORER SPORT TRAC 4.O
Hello,
Very common concern with the Explorer, Explorer Sport Trac and Ranger with the 4.0l SOHC engine! The upper and lower intake manifold gaskets fail, causing vacuum leaks..It can be Extremely difficult to detect these leaks, because they only leak intermittently (usually in the AM after a cold soak)... As the engine warms up they seal back up! Sometimes the vehicle will idle rough, surge or stall after initial start up, then the symptoms will clear after it gets to operating temperature... Usually there will be no driveability symptoms at all, except the engine light coming on and setting lean codes.. The gaskets have been redesigned to correct this concern..
Bill Andrade Ford Master Technician/ASE Master Technician
SOURCE: 01 ford explorer sport trac rear timing chain diagram
They will not loan you the tools.....how else will they continue to rip off the average garage junkie and make lots of money?
SOURCE: 2001 ford explorer sport, door keypad reset
How to find the Security Keyless Keypad Code on the 1995-2001 Ford
Explorer or Mountaineer and how to use the Keypad functions. The factory
code is also printed on a label which is installed on the Remote
Anti-theft Personality (RAP) Module. This is the module that controls
the keyless entry system. It is
located in the left rear quarter behind the removable panel (see photo).
You will need to turn the two thumb screws counter clockwise and take
the plastic panel off to be able to see the unit. A flashlight may be
helpful in seeing the code. You are looking for the module and the 5
digit code on it like the one shown below.
Now that you’ve got the code I’ll tell you how to use the Keyless entry
and set-up your own code.Make sure when pressing the controls on the keyless entry keypad you press the
middle of the buttons to ensure good contact with the controls.
Check this for Programing the Keypad.
Hope this help (remember rated this comment).
542 views
Usually answered in minutes!
×