20 Most Recent
1996 Subaru Legacy - Page 4 Questions & Answers
I have a grinding noise from the alternator. Suspect it is running a bearing.
If your sure its coming from the alternator loosen or remove the belt and turn the pully by hand and check for excessive end play. I hate to say it but you probably need a new alt. if thats where the noise is coming from. You can also get a piece of 3/8th vinyl tubing about 3 ft. or so. hold one end to your ear and use the other end to isolate the noise.
P.S. keep that tubing in your car. It comes in handy when you want to find strange noises under the hood
2006 subaru outback, missfire code - cylinders 1
had miss fires with my 92 legacy gt.typical suby fault coil packs always go out in saying that check that you dont just have a foul or failed spark plug. easy fix if it is the coil i replaced mine with 2nd hand ones from the same model usualy find them at most subaru specialists wreckers etc depending on model.
Replacement of coolant temperature sensor
located under intake in water crossover pipe,you can access the sensor by removing intake chamber box,then pcv hose connected to the block,the connector is orangeish 2pin,use a 19mmdeep socket on a 3/8 ratchet to get it loose,make sure engine is cool,also make sure there is a new brass washer with your new sensor,sometimes the old washer comes off when removing the sensor,sometimes it sticks to the pipe,some coolant will escape so make sure to top it off
How to kill the door beeper?
you can remove the switch for the drivers door and tape the plug then cover the hole. its located right below the latch the on door opening
I am needing to replace the fuel relay switch on
my car wont start ive changed plugs and fuel pump and now ive been told it could be the relay switch but dont know where it is of if it is that any suggestions and my car is a subaru impreza 93
Not finding what you are looking for?