20 Most Recent
1987 Volvo 760 - Page 8 Questions & Answers
My volvo xc90, 2004 model sometimes shuts off while driving( trans affected and all gaudges shuts off.
Obviously an electrical issue. You'll need to isolate what's off and on when this happens to trace the wiring for the non-working components with a 12V test light. I would suspect that if other items are still working such as the headlights, you should check your ignition switch (electrical) to make sure it's not having issues. Other than that, your ground wiring must be good for the Pos+ wiring to work properly so I would inspect that as well. Good luck:)
How to reset immobilizer on 2001 volvo s60
Hi. Here are directions to reset your immobilizer. The ignition switch has for positions. You will be using two (Accessory and Run). NOTE: Do not start the engine during the reset procedure.
NOTE: Look at your gauge cluster and identify the trip display and reset button.
(1) Turn the ignition switch to the accessory position.
(2) Set the trip reading to TRIP 1 (T1) and push and hold the trip reset button.
(3) While holding the reset button, rotate the key to the RUN position.
(4)Hold the reset button until you see the triangle in the dash flash yellow. Once this starts flashing remove your finger from the reset button. Shut the car off, verify light is out. repeat once if necessary.
Operating temp of coolant
The normal Volvo Penta D13 engine temperature operating range is 194*F+/-5 to 221*F +/- 5 degrees. The engine coolant is overheating if it's around 240 to 250 degrees.
How do I clear code 013D on my Volvo s40 without going to dealer? Had it turned off for $80 and came back on.
You already asked this question, and it was answered pretty accurately previously. Here is the Volvo bulletin on this SRS (airbag) fault code.
Look at the two pin connector under the passenger seat. Remove the center console and checked the SRS control module plug . Measure the resistance between pin 37 & 38 of the control module and 1 & 2 of the plug under the seat.
Code:
SRS-013D
Definition:
Left SIPS Bag. Faulty Signal
Description:
Diagnostic trouble code (DTC) SRS-013D is stored if the control module registers that the resistance is too high in the ignition circuit. The SRS indicator lamp is lit.
Cause:
- Open-circuit in the cable or contact resistance in the connectors between the SIPS airbag and the SRS control module.
- Open-circuit in the SIPS airbag (resistance too low in the igniter).
Not finding what you are looking for?