Top 20
1998 Mitsubishi Montero Sport Questions & Answers
I have an 98 montero sport ls v6 3.0 auto 4x4. It
Probably the oil filter is blocked.
Warm it all up with a 30-45 minute drive & then change the oil in the gearbox whilst it's still hot. Make sure you also change or thoroughly clean the gearbox oil filter at the same time.
After that you're looking at the tension bands & the dog-clutches, which are a specialist mechanics job.
How do I replace the airbag on my 1998 mitsubishi montero sport
Hi,
Unfortunately the horn switch is not serviceable on this vehicle.
The horn switch is built into the air bag assembly and can not be removed safely, nor are service parts available for it even if you could. If there is a problem with the horn switch, the air bag must be replaced.
Hi guys, did you ever
99% of these kinds of unattended acceleration is driver error with a mix up between the brake and gas pedal.
Steering does not lock unless you turn the key to the lock position.
1% is a mechanical failure but switching the key off and depressing the brake usually controls the situation.
I have a Mitsubishi Montero sport 1998 code p1750 need picture of location
Picture of location for what ?
First thing to do with any transmission codes is check the fluid and clear the codes after recording them then redo a test drive cycle
A P1750 can be anything from a wiring short or a bad TCM
It could be the converter clutch solenoid, shift control solenoid, pressure control solenoid or engine control module has failed.
If the code comes back then you will have to check the wiring harness to the transmission and test the solenoid pack and see if they are malfunctioning ! Your best bet , take it to a qualified repair shop .
Key wont unlock doors 1998 montero sport
mepindo.market/...web/
1998-
mitsubishi-
montero-sport-manual.pdf
Get free access to PDF Ebook 1998 Mitsubishi Montero Sport Manual at our ... If you are looking for Linear Functions At The Tank Answer Key, our library is free ...
What could be the cause of oil burning and excessive smoking?
Sorry to tell you this, but it sounds like they may have put your rings in wrong or one broke right away. If you want to verify which cylinder it is, pull the spark plugs and see which one has oil on it. I suggest you take it back to the place that did overhaul and have done over.
How to align the timing marks on camshafts and crankshaft when replacing a broken timing belt on a 3.0liter engine
Better make sure it isn't a no tolerance engine first. If it is, the pistons could have slapped the valves. This will bend the valves, break them, or punch holes in the pistons. I know the 4 cylinders are not tolerance, but not sure on the six cylinder. You can do a leak down test, but you have to basically pull the cams, So the valves are shut. Then put air pressure to each cylinder. If the cylinder is bad it will leak air(a lot) out of the throttle body, exhaust(out of the tail pipe) or into the crank case.
Not finding what you are looking for?