20 Most Recent 2000 BMW Z3 - Page 6 Questions & Answers

it sounds like it is either a weak battery or the solonoid on the starter motor

http://www.bmwusa.com

Or call your local dealer.

You have damaged the exhaust carbon trap most likely, you might try resetting the light and running it for a week and see if it clears itself, you may get lucky

Mine came with Michelin Pilots. I believe this was the standard OEM for the Z3.

-bob fitzpatrick

What symptoms are you getting when driving the car, if any at all? Sometines a loss of power can be an exhaust problem or if you find the car is revving on its own accord when ticking over this points to a sensor problem. All depends on what the problem is the price, this can actually be cheap to repair, but also expect to pay over £70 for the initial diagnostics.

Pete.

try wheel speed sensor. the

these car also have a pad sensor. and will cause this problem and if the breaks are thin they need replacement. that would be the cheapest fix.

This car is actuelly equiped with 2, and it depends on what kind of connection you have. The OBD2 connector is located on the passenger side to the left of the glove box. The other connector which is a round connector is located under the hood on the drivers side next to the abs module.... It will have a round cover over it. I’m happy to assist further over the phone at https://www.6ya.com/expert/jonathan_3a3c556b4b17d1d2

may be cam sensors...

You can downloading from the internet or go to a part store.

Go to the menu than press specification and then reset specifications.

you can get guide from many sites.. i know few error codes/ fault codes, wiring diagrams, schematic diagrams, torque specs, engine info, switches functioning, assemble, disassembly, complete refurbish, repair, installation every single thing is covered within seconds u can get the access and it's totally illustrative complete

Hi If you've had the tracking done when you had the track rod ends done and it's still pulling to the left I would check your tyre pressures 1st then look at the tyre on the left of your vehicle if its misshaped this could cause pulling Hope this helps Nick

Hi, Easy way to get over this is run a cable from working fog light to none working fog light this should then work. Only other way must be the left fog light is not earthed properly run earth wire to the vehicles body. Please give feedback at [email protected] Thanks, Malcolm Campbell.

have the OBD codes read as a starting point , should point you in the right direction