...got a locking device to hold the turn table steady during shipping. make sure the belt is on right. make sure the belt is not to tight some newer turntable's require power to turn as well anti ...
have akai ap-b110 turntable needs belt. Can you tell me the length/specs If you have the turntable belt: ? State the type of belt used (Flat, Square, Round). ? Pinch both ends of the belt. ? Measure ...
turntable doesn't start My turntable doesn't start.If I spin it by hand there is clearly audio. It is a semi-automatic belt driven table. I think the belt is worn but I want to know if there are other
I have a Pioneer PL-61 turntable I plugged it in and put the speed on both 45 & 33, with no movement. Any ideas? It was given to me by a friend Take the turntable off. Check the motor to see if it
...belt is not too tight as this will slow the motor down as it tries to turn the platter. I would also suggest a little light oil (sewing machine oil is ideal - NOT WD40) on the motor spindle shaft ...
...while slowly rotating the platter look through cut out in the metal, at one point you will see a motor spindle and a belt. Feel the tension of the belt , it should be wrapped tight round the
how install belt on pioneer turntable model PL. I tried slipping the belt on the inside ring and then to the pulley motor. but belt seems too loose and doesn't hold. is there an image how to do this? ...
...it in the opposite direction loosens it but it freezes in the regular direction. Any thoughts? Hi, belt is too tight. That model JVC takes belt FRX 23.6. We have them in stock. John. ...
turntable spinning to fast You will probably find if its a belt drive that the belt is too tight
...length of the old belt to approximate the correct length new belt. Be careful in your measurements. Too tight, or too loose a belt, can make your issue worse or better, depending on your
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions