Questions & Answers for: Chevrolet Corvette spring

...sits about 2 inches lower than the other side, cant figure out what it is, got any ideas?? The rear spring has weakened over time. Also, check that the Stabilizer link to the rear spring, on the left ...

My 1994 Vette My ride is too firm, I would like to soften the ride. Is it in the shocks or springs? The ride is based on shocks. The coil spring only gives you the ride height.

...an 81 corvette and it leans lower on the drivers side by a quarter inch. I replaced the rear mono spring, shocks and body mounts and nothing fixed the problem. I tried to adjust the mono spring to ...

...column and is connected with a rod to the key tumbler assembly. This rod is returned with a spring that is part of the switch and may have a boost spring higher up. A manual would help as I ...

What causes yaw in rearend when car starts to decelerate on my? most likely cause is a weak spring,replace both,matched pair.another cause could be rubber bushes.jack up car to take weight of springs ...

WHAT IS THE PROPER WAY TO INSTALL A Composite Rear MonoSpring ON A 1979 CORVETTE you bolt the leaf spring to the axle first it locates on the bolt head that holds the spring together into a hole in ...

73 corvette steering rack spring How do I replace a broken steering rack spring? Mine is broken and I can't get the key out of the cylnder go to www.automecanico.com translate this amazing website

How to install a door hinge spring I found the spring, but and understand it takes a special tool. Looks like a bent screwdriver. How do I use the tool? A door hinge spring compressor such as ...

...you dont have to push the button down to down shift from 3 to 2. How do you repair this The return spring inside of the shifter might be weak or broken, or the tab in the shifter gate slot might

I have a 86 vette the front end is sitting too low . What do you think the problem might be THANKS Changed shocks had Bilstein on the bushing were bad put KYB shocks on but it did not raised the front