20 Most Recent 1990 Chevrolet Corvette Questions & Answers


https://www.gmheritagecenter.com/docs/gm-heritage-archive/vehicle-information-kits/Corvette/1990-Chevrolet-Corvette.pdf

1990 Chevrolet... | Answered on May 16, 2019


yes, that could be in fact the problem, some cars have a sensor for the seat belts and if you do not engage the belt the it may not start

1990 Chevrolet... | Answered on Dec 25, 2018


Is it the 5.7 L? It's mounted on the transmission. countrycurt0

1990 Chevrolet... | Answered on Dec 13, 2018


Does the vehicle crank and not start? Your mechanic must re check his work then inspect battery, spark, fuel pressure 30psi min,and computer codes. Good luck and always have your mechanic test drive vehicle to confirm repair.

I’m happy to assist further over the phone at https://www.6ya.com/expert/richard_9a19ee73dfa4686a

1990 Chevrolet... | Answered on Feb 21, 2018


Which is it ?????
Question about 1990 Chevrolet Corvette
Open Question
I have a 1999 corvette coupe

1990 Chevrolet... | Answered on May 09, 2017


It sounds like an intake manifold vac leak. After the engine warms up use a can of spray carb cleaner at all edges of the intake. Use short bursts of the cleaner and see if the RPM changes. If it does you have a vac leak. That means replacing manifold gaskets.

1990 Chevrolet... | Answered on Mar 03, 2017


Check engine light on ? Did you have it hooked up to diagnostic tool ? Could be a few different thing's , engine sensors , fuel system problem , plugged exhaust etc... If unfamiliar with this your best bet would be to take it to a qualified repair shop .

1990 Chevrolet... | Answered on Sep 20, 2016


This may be related to the antitheft system. The system is known for turning off the starter and/or injectors when it fails. Normally when the injectors are turned off, the car will run for a second or two, and then stall. When it's the security locked out starter, you won't even hear a click when you turn the key. Is there a light on the dash that says SECURITY or a picture of a car with a lock through it? This is a common problem worth looking into. http://www.diy-gm-security.com/
26285845-cqronsdmd2w20g51c2h5mdro-4-0.jpg

26285845-cqronsdmd2w20g51c2h5mdro-4-2.jpg

1990 Chevrolet... | Answered on Sep 19, 2016


check the relay under the hood .

1990 Chevrolet... | Answered on Jun 12, 2016


If you have tested for voltage at the pump wiring and find none, remember the ECU may not supply pump current if it finds signals missing from critical sensors. There is also an inertia switch in the circuit I think.

1990 Chevrolet... | Answered on Jun 12, 2016


Replace the relay or resistor first. Relays can stick closed, will cause a fast blower. Resistors can be fast to slower speeds. After that is burnt wires somewhere. Personally , I look at the wires first, Check them for ground shorts and impedance. Have an Ohm/volt meter?

1990 Chevrolet... | Answered on Dec 31, 2015


Hi Jackie , It doesn't have to have a code stored in the ECM memory for a problem too exist . need some more info from your if you would like some ideas as to the problem !
What engine does yours have ? 5.7L ? What type fuel system does it have - TBI - throttle body fuel injection ? I had vehicles at the Chevy dealer I worked at with this type fuel injection , where the engine raced really fast . Vacuum leaks , bad plug wires can cause this problem . The engine computer is compensating for more air entering the engine ! After fixing the problem it still was racing , you have to drive the vehicle an get the speed up over 35 MPH for the ECM to reset !

1990 Chevrolet... | Answered on Jul 24, 2015


Make sure your pats key is clean. Sometimes the chip gets dirty. Also try disconnecting the battery for a couple of minutes. This will reset the system...

1990 Chevrolet... | Answered on Jun 09, 2015


Are you sure your vehicle has one? If it does, it would be located on the steering column.

1990 Chevrolet... | Answered on Mar 04, 2015


I suggest using the original fuel injectors that came with the vehicle.
Buy them from the dealership and 97% of the time your problem will be gone. Always test drive vehicle to confirm repair.

I’m happy to assist further over the phone at https://www.6ya.com/expert/richard_9a19ee73dfa4686a

1990 Chevrolet... | Answered on Feb 15, 2015


No there are different 700R4 transmission, well that not quite true. The 700R4 had many jobs to matted to Corvettes to SUVs, the internals are where the differences were in the 700R4 such as the servo's and boost valve which can be easily replaced. Best thing to do is to got to a Transmission shop that can build a transmissions for your Corvette or buy a replacement 700R4 for your year of Corvette. That is why the shift points and firmness are different in a Corvette then a Cadillac while they both have 700R4 in the 1990's. Be bad for a Corvette to shift like Grandma's Cadillac going to play dingo. Good luck and hope this helps.

1990 Chevrolet... | Answered on Feb 04, 2015


check this out.. I used it on one of my cars.. it will bypass it and u can do it yourself

1990 Chevrolet... | Answered on Nov 09, 2014


Is it an aftermarket radio??? Normally they have a 5A fuse on the back of the unit itself, or in line of the radio's power wire.

1990 Chevrolet... | Answered on Sep 22, 2014

Not finding what you are looking for?
1990 Chevrolet Corvette Logo

266 questions posted

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

84619 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Corvette Chevrolet

  • Corvette Chevrolet

Most Popular Question

heater blower motor runs witch out key

  • Cars & Trucks
Loading...