20 Most Recent 2001 Chevrolet Corvette Questions & Answers


these all get there infomation from the abs sensior's at each wheel one of the sensior's could be malfuctiong or the fuse could be bernt out

2001 Chevrolet... | Answered on Mar 10, 2019


You can go to the dealer for this code or you can go here www.radiocode.com for a lot less money. The radio security code unfortunately is not free. It was given to the original owner along with the new car factory documents like the owners manual and such, it was on a little card.

2001 Chevrolet... | Answered on Feb 03, 2017


What do the lights do when you try to start it? A battery can be strong enough to power lights, etc, but still not have enough power to handle a big draw like the starter motor.
You could also check cables going from battery to starter relay and relay to starter.

2001 Chevrolet... | Answered on Feb 27, 2015


The Light is on because the ABS system for your Anti-Lock Brakes has failed....the Brakes will still work...but the ABS wont...basically if you slam on the brakes... you will lock up your tires as if it were an older model car before ABS came out. The most probable cause is a wheel sensor that "Counts" the notches on the wheel axle near the knuckle has failed. Could just be dirty...mis-adjusted or broken.i would need more details to determine the exact cause. Hope this helps.

2001 Chevrolet... | Answered on Jan 08, 2015


Get a multimeter check for DC voltage at the light sockets. No voltage means blown fuses. You can also use the multimeter to check the bulbs to see if they have somehow blown.

2001 Chevrolet... | Answered on Dec 06, 2014


Locate the brake on off switch, remove it and replace with a new one. Switch is usually located near the brake pedal under the instrument panel. Lay on your back and slide in under the steering wheel and look up and under the dash by the brake pedal, follow it up and the switch should be right there.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/michael_2496c4f07ad24453

2001 Chevrolet... | Answered on Sep 02, 2014


right behind the glove box just take glove box out

2001 Chevrolet... | Answered on Jun 24, 2014


Cranshaft pulley is bad,probably has rubber damper which is damaged or worn loose.Don't run it this way.Get the pulley replaced now. don-ohio

2001 Chevrolet... | Answered on Apr 22, 2014


check your trans fluid.smell it if it smells burnt you need powerbans..if it smells ok you may need the trans fluid filter replaced..

2001 Chevrolet... | Answered on Apr 16, 2014


If cleaning the contacts and grounds doesn't resolve your problem, the next best thing is to have your EBCM re-built. Here's a cut and paste of vendors that have been used successfully in the past;

1. well just wanted to let everyone with this problem know found a place to get this thing repaired and after talkin with Brandon got him to repair and upgrade it for 150.00 plus 8.00 for return next day air .
this is a great price if ya look at cost to replace and customer service was also great. he will gurantee the ecbm for as long as you own the car.So if ya have this problem give him a call , site is absfixer.com or call 877-648-7530


2. The name of the company is Auto&Truck Electronics. I am in no way affiliated with them, nor do I recieve any discount or monetary consideration for making this post. I'm making this post in an effort to save you guys some $$$ and hopefully help to prevent future failures given the problematic part could fail again if replaced with another flawed design part(assuming they haven't corrected whatever tends to break). I was a bit leary of this whole deal since I didn't have any references to say it was a good deal, or they did good work etc...
So if anything use me as sort of a guinnea pig in this matter. I had a GREAT experience both with the service of the rep and of the part they fixed for me. In my opinion it's $$ well spent to both save alot of $$$, but also, from what I'm lead to believe, have a much smaller chance of having the part break again. They have a 5yr warranty on their work as well. Their # is 1-800-550-0674


3. I had to have my EBCM re-built 4 months ago. Put it back in the car and no more codes. The company I used is on ebay, but I contacted them directly at http://autoecu.com/ Their phone # is at the bottom of the web page.

Hope this helps you guys out!

2001 Chevrolet... | Answered on Apr 10, 2014


when I hit the gas hard the wont go in second gear

2001 Chevrolet... | Answered on Apr 10, 2014


CAUTION: The engine must be running when the transmission fluid fill plug is removed, or excessive fluid loss will occur. Transmission fluid may be hot. Since the actual fluid level is unknown, stand clear when removing the fill plug. Have a container ready to capture any lost fluid. Do not turn the engine off with the fill plug removed, as you can be injured by hot transmission fluid being expelled out of the oil fill opening.
48f3cbbe-7db7-4b3f-a212-587b374741ab.jpg

2001 Chevrolet... | Answered on Jan 25, 2014


Hi,

No there is no tube/dipstick under the hood as the tranmission is in the rear of the car. You need to lift it up level and then check the fluid.

I own a 01 vette as well. Change the fluid 50k the first time and check/replace every 30k after that. Just a standard filter fluid change is fine. No need to flush.

2001 Chevrolet... | Answered on Jan 25, 2014

Not finding what you are looking for?
2001 Chevrolet Corvette Logo

164 questions posted

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85104 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Corvette Chevrolet

  • Corvette Chevrolet

Most Popular Question

transmission

  • Cars & Trucks
Loading...