...metal heat sink. Chances are, that IC has burned out and stopped working. Replacing that IC should restore your convergence. If you do not have experience replacing IC's in projection sets, allow a ...
...restore full color and brightness without changing any parts whatsoever. Otherwise, the convergence chips are located on a large metal heatsink and have a generic part number printed on the front of ...
restore some of the original shine with 000 steel wool and chrome cleaner, but the minute you run it again it will change back. Some of the colouring is an actual chemical reaction in the metal itself
...metal disc. The outer edge is even a slightly different color, so you can identify the two parts. In my case, the sound was emitting from the outer edge, as opposed to the center portion of the disc. ...
Question about Photoshop® CS3 Extended Full Version Corporate License for PC (29400084)
...restore defaults. Under edit, check your color preferences. You will see that you have selections from the drop down at the top of this popup. Make sure it is not custom. North American general is ...
Question about Photoshop® CS3 Extended Full Version Corporate License for PC (29400084)
...restore the original color and luster. There is really no easy way short of sanding lightly and repainting. (I am told that "tremclad" paint intended for exterior use on metal in tough situations is ...
Question about Deskjet 460c InkJet Printer
...Color LaserJet 2600n Printer - Changing Print Cartridges webpage (http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?objectID=c00314345) . 3. If the issue persists, perform a firmware ...
...metal. Remove the cover. Try reseating (removing and reinserting) your memory (try one module at a time to test). If still a problem, boot your system to Safe Mode (press F8 repeatedly). Go to System ...
...metal cutting involved? Have not done this myself, but try Carpenter restoration products. He has several magazines for parts and restorations from cars, trucks, to tractors. Also consider that ...
...restore the metal finish (if not severely damaged) of most appliance cabinets. I hope this helps you. Note: To ensure the rubbing compound will give you desired results, test the product in a small ...
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions