...is a spring which holds the hub out, removing this spring and replacing the rubber dust cover and hub will lock your front hubs in continious. as is done on later models, This has worked for my 98 ...
...front locking hub on 4x4 ford truck wont lock in I had like a bearing noise coming from my left front wheel one day,after that when I needed 4x4, I locked in the hubs but I only have rear wheel ...
...ranger 4x4 when you push button for 4x4 nothing happens, only use about once a month, hubs are man. THEY IS A SOLINOID ON THE SIDE OF THE TRANS. YOU NEED TO CRAWL UNDERNEATH TO ACCESS IT CHECK TO SEE ...
...ford ranger auto 3.0L sounds says its dropping into 4x4 when you turn the switch you can here it click in but its not engageing the front axle any one know what to do? ck frt drive shaft out of ...
...lock in my 1994 ranger will go in 4x4 but the auto hubs want lock in Sometimes you may need to go into reverse then back to get the desired effect. The hubs probably need to be cleaned and
Question about 1994 Ranger Supercab
...auto hub. Be prepared for some sticker shock on those hubs. they are not cheap. The usual fix for this is to replace the front axle ujoints and what ever hub is making the noise, hopefully just
Question about 1988 Ranger
ford ranger 1990 4x4 when hubs are engaged 4x4 still dont work and control lites come one and off on own when i turn my 1990 for ranger 4x4 with manual hubs and push button transfer case the lights ...
Question about Ford Ranger Edge/Edge Plus Model 2001-2003 F. Valance Panel Primed
NEED TORQUE SPECS ON FRONT HUB ON 2003 FORD RANGER EDGE 4X4 HUB TO FRAME AND AXLE front axle nut torque specs are 162/220 ft lbs
Question about Ford Ranger Edge/Edge Plus Model 2001-2003 F. Valance Panel Primed
1994 ford ranger 4.0 manual starter disengages before my truck starts in only turns a quarter turn before disengages Starter relay replacement - Ranger-Forums - The Ultimate Ford ... www.ranger-forums
Question about 2000 Ranger SuperCab
...front wheel hub 4x4, 4L, front wheel hub torque specs. Do not put more then 100 psi. It likely depends on the type of four wheel drive system you have. If your system is live axle then it's 162 lb-ft ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions