Questions & Answers for: noisy clutch release bearing

Question about 1999 Golf

1 Answer

...soon as clutch is released the noise goes away That will be your clutch release bearing.It should be ok, if noisy for a while but make sure you change it with the next clutch assembly

Ad

Question about 2004 Super Duty F 550

1 Answer

Noisy Throughout Bearing - My truck has 35,000 on it and the bearing is really noisy when I puch in the clutch. The clutch release bearing has gone you'll have to replace it, gear-box down!

Ad

clutch is noisy,when i depress the clutch the noise goes away this noise is caused by a noisy clutch throw-out/release bearing, that is the part that presses against the pressure plate and disengages ...

...clutch thrust would be noisy and slow the tick over when you depress the clutch if it was faulty. If the car has ever been left standing the first motion shaft bearing can dry out and rust a bit then ...

...noisy clutch release bearing. The clutch release mechanism might be adjusted too tight which causes the bearing to turn, when it should be disengaged. This will wear it out and start to wine. Someone ...

...noisy after a few minutes of driving. It rattles when i let off the clutch Yes, it can. The release bearing must be adjusted to fully release. this may not be a release bearing, so investigate ...

Question about 2000 Corvette

1 Answer

clutch is noisy. If i depress the clutch pedal, the noise goes away. the lay shaft bearings inside the gearbox are worn,remove level plug and pump a grease gun full of grease into gearbox as this will

...near the end of their life, they do get noisy. It may go on like that for a long time, but sooner or later, you will need a new release bearing, and probably a new clutch and pressure plate as

Question about 1994 Pathfinder

1 Answer

...noisy? like singing or whistling when the clutch pedal is pressed? To replace it, you will have to pull the transmission off, so might as well get a new clutch pack. It will have a new clutch disc, ...

Noisy clutch, spinning sound, intermittent If it's a rattle type sound it maybe dual mass fly wheel noisy too much play in it, requires replacing!It also could be release bearing noisy too if it ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...