Questions & Answers for: new timing belt tooth

...if there is 4 diffrent sizes. you should also make shure that the timing belt tensioner isnot worn or in need of replacement. this will help prolong the life of the new belt good luck with this ...

Ad

Question about 1993 Metro

2 Answers

...new car to the old car??? Are they compatible???? As long as they are the same type of engine ( I believe they should both be 1.0L 3 cyl engines). Most parts for the Geo Metro from 1992 to 1994 ...

Ad

...timing belt on a escort YOU MUST replace the water pump. If you don't you will keep replacing the belt over and over again. Also check your tentioner and make sure you have the correct belt. I always ...

new tp sensor would it be the mas air flow or the temp. sensor? most probably the mass air flow if you have not recently had a timing belt done. If you have recently had a belt done seems that the cam

Question about 1990 740

1 Answer

...new timing belt, as when you removed the old timing belt. It's also recommended to replace the unit used for tightening the timing belt at the same time. This is only a short description of the most ...

Question about 2003 CR-V

1 Answer

...timing Belt and it should be changed not later than 70.000 km. If you are the original owner then you know the actual maint. on the vehicle. If you purchased it 2nd hand depending upon where you ...

...timing cover , check out timing marks by turning engine clock wise only. after fitting a new belt I all ways set tension and rotate engine twice and recheck marks , saves a lot of time if a tooth

How do i fix a skipped tooth on a timing belt cuz ive done tried everything else If you have even 1 broken "tooth" or drive rib on a timing belt you MUST replace it with a new one

new timing belt. Read the number printed on the belt and look it up and make sure you have the correct belt. This problem can be caused by one tooth too many or too few on the timing belt or incorrect

Question about 2003 CR-V

1 Answer

...timing marks put on the new belt and turned the motor 2 times, all timing marks stayed right on. after putting the motor back together we fired it up and it sounds like piston is hitting the valves. ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...