Questions & Answers for: kitchenaid mixer turns high speed

Mixer turns on revs to a high speed and then quits This happens regardless of which speed is selected; mixer stays on spinning very fast for 4 seconds and then shuts off. Behavior repeats. I replaced ...

...kitchenaid and in the middle of creaming butter and sugar together, it stopped working. Turned it off, switched plugs, let it cool down, etc - it won't turn on now and isn't even making a sound when ...

...Kitchenaid mixer at any speed, it ramps up to high speed and then shuts down after maybe 30 seconds. You need a reputable repairman. My gears were stripped after trying to mix a very thick dough. It ...

KitchenAid - model ksm90 - has a high pitched whining noise - when I beat on high speed. It keeps whining for a second or 2 when I turn it off. The mixer has been wonderful - although is getting quite

KitchenAid mixer speed surges high and low uncontrolably When turned on any speed the mixer speeds fast and slow making it impossible to mix with any control. You can get the high speed back if you ...

kitchenaid mixer on high all the time when i turn it on there is just one speed and thats high I think that the mechanical speed control is stuck. Unless you are not afraid to take the mixer apart, ...

...kitchenaid mixer run on high at all times The mixer run on high at all times If your mixer only runs on high speed there are 3 things that can cause that. The first thing to check will be the speed ...

...Kitchenaid Artisan stand mixer is spinning too fast after a voltage fluctuation. I was using the mixer to knead dough, I switched it off for a few seconds and when I turned it on again it started ...

kitchenaid 5qt mixer dont turn on and the other speeds setting are all the same speed The solution will probably be under the back cover. Are the switch contacts touching at speed 1? Are all the wires

...KitchenAid KSM90 Stand Mixer and it will only run on Speed 8. Any ideas? Your description is very incomplete. Does it not start turning until the lever is at position 8 or does it run at high speed ...