Questions & Answers for: computer 1986 300zx

...300zx haveing trouble with it hard starting and flooding when i first start it up its blowing blue smoke for just a minnet and smells like its running rich i have replaced the fuel pump,pressure ...

...now car starts for 2-5 seconds then stalls or sometimes wont even start Probably fried the computer, or the electronic ignition. Are you getting any trouble codes? It is possible the ecm is ...

...1986 Nissan 300ZX will not get over 2000 rpm. I thought it might be a fuel problem so I was told to replace the mass air. Well that obviously didn't work so then I pulled the o2 sensors to see if the ...

...300zx non-turbo is able to start and idle but engine dies after about 30 seconds as if fuel is cut off. Engine dies immediately if you try to rev the rpms above idle. This problem began immediately ...

...1986 non turbo Nissan 300zx Awhile ago, while i was driving home. My car started to over heat, then blew a water hose and water got everywhere. My father and I have replace all water hose's , ...

wont stay running someone told me to resit the computer.could that be right and how do you do that. No reset or anything, that will keep it running, other than properly diagnosing the issue and making

...1986 Nissan 300ZX. The problem occurs when you have driven the car in stop and go traffic, or you have driven it for awhile, you turn it off, and it does not want to start. It takes 3 to 6 times to ...

...1986 300zx non turbo injectors on pas side not working have power both wires and can ground signal wire and they will fire not getting ground signal could this be computer related traced injector ...

...on my 86 300zx please help Having trouble locating the ignition control module on my 86 300Zx plz help thx. I don't believe it has one. The computer sends a signal to the power transistor by the

...you in advance . if I remember when you unplug these and the car starts the MAF is bad and the computer goes into backup