My compaq presario f500 will turn on for a few seconds the turn off I've read that it is a video chipset overheat, so as in xbox 360, or compaq v3000, you must use a heat gun, and resolder it
Monitor moving on its own For awhile my Compaq P1220 monitor has been 'twitching' and swallowing up the sides of my screen. It does not connect to the width of my computer well, and will resize/change
...alive, how do i troubleshoot (compaq nc 6000) hi open laptop open board look back side board near proccessor side ic maxx 1987 heat whit heat gun station 2 3 minuts then asssembel turn on and ...
my nc6000 laptp when power on does not display any thing at all,what can i do hi open laptop open board look back side board near proccessor side ic maxx 1987 heat whit heat gun station 2 3 minuts ...
Question about 449901-001 - HP Presario V6500 V6600 V6700 V6800 Series Full-Featured (FF) Laptop Motherboard
...compaq presario v6500 laptop and it wont turn on, i was using it fine then shut it down normally, then next morning went to turn it on and nothing.. the power cord light comes on when plugged in and ...
...the 8 pins on a Compaq nVidia TNT2 Pro AGP Video Card 180-P0016-0000 heres what you can do your going to have to buy satter gun and get copper tubes for gun and then you can reconnect the 8
Has anyone else had to reflow the solder on the MAXIM1987 chip on their HP nc6000? Try a heat gun, such as a heat gun used on shrink wrap. A hair dryer might do the trick. What I do ...
compaq f700 wifi not working Try to change your wifi card to Broadcom wifi card. If problem still happen, you need to reflow your GPU Nvidia with hot air gun around 30 seconds. Thanks
...compaq nc6000 ? Yes you can if your talking about the DC jack they run about $6. This involves a solder gun a complete tear down of the laptop and a steady hand. My advise would be pay a shop to do ...
...compaq nc8430 that is not displaying anything. I tried to connect the external monitor but nothing showes up. The startup screen is not showing. Could it be the system board? Try reflowing the solder ...
Usually answered in minutes!
19,138 Questions
12,216 Questions
7,310 Questions
7,277 Questions
5,472 Questions