...bleeding prob or master clutch cylinder, how can you tell? pull the boot back on the master and see if it is wet do the same with the slave it is a bleeding problem try to bleed it more then adjust ...
...clutch won't engage I have a 1992 YJ with 260000 kms on it, original clutch. For the last few months the engine will randomly race/surge ahead of its own accord if I'm at a stop with the clutch ...
...Clutch cylinder down to the slave cylinder by the transmission. The bleeder valve should be on the passenger side of the transmission if you have a 4 cylnder and drivers side for a 6. make sure you ...
Bleed Clutch @ slave cyl. Please discribe the process. Thank you most clutch and slave cyinders bleed by constantly working the clutch pedal. its tiring and can be a long process. Also keep an eye on ...
clutch for 1992/ 6 clynder/ 4.0 litre Wrangler. I have water and as a result a soft clutch pedal which is not releasing the clutch No photo, but if you follow the line from the master cylinder for the
clutch pedal is going to the floor. about 2 mos ago replaced the master cylinder bled the system worked good now its doing the same thing. if i bleed the system it works good again for a day or so. ...
bleeding breaks, it pokes out of the front bell of the transmission. Bleed it like breaks, have someone push on the clutch, and hold, you open and let out the air, close have them let up, repeat until
...Wrangler, 5 Speed Manual Transmission. Replaced the Entire Clutch along with slave cylinder, but not master. It worked beautifully for a few weeks, now when I push in the clutch, I barely let out and ...
I need to bleed the clutch slave cylinder but just not sure if I am loosening the right part. Can't find any pictures. There is only one bleeder valve on the clutch slave cylinder so you can't
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions