convergence no adjustment on this mitsubishi 40" vs-430ca projection tv I have changed the convergence chips and had no change there is no convergence adjustment function happening with the alignment ...
...Voltage The battery temp sensor is built in to the PCM (ECU). The input from this sensor is used to adjust the alternator charging rate based upon the ambient tempature around the battery. The P1493 ...
focus can it go out of focus? On CRT projectors, there is a part called a focus block with adjustments for each picture tube. A sudden loss of focus is pointing to something else, a change in the high
...thanks Aaron. 3.0 V6 engine? Key on, engine off the voltage on the Brown/White wire will be .5 to .75 volts. If its not, loosen the 2 screws and adjust it. 20% at idle is NOT correct. should be at
tps 1.5 engine adjustment procedure need tps 1.5 engine adjustment procedure and idle mixture screw on top of trottle body., car doesn't idle correctly when drive or reverse gear is apply, worst when ...
...we have no red color at all there is a voltage adjustment that you can adjust on the front of the crt< but be careful and turn it in small increments, you can usually get to it from the front ...
Question about WS-65511 65" Rear Projection Television
adjust it ???? g2 is also known as screen voltage. the adjustmen knobs are located on the high voltage block behind the front panel. its a black square bloc with 6 adjustment knobs ussally label focus
Question about WS-55908 55" Rear Projection Television
...of dangerous high voltage. See if there's a picture after turning up the red, green, blue, voltage adjustments, if not then vertical sweep, Flyback, or convergence need servicing. This repair
...which you can adjust the screen voltage and focus voltage. If the potentiometer in side it have some problem then this problem can occur. Have added the image for two items for your reference. ...
...down the voltage on all 3 crt's. You have a red one, a blue one and a green one. Slowly adjust the knob down until you don't see the shadow any more. Then adjust your color in the user
Usually answered in minutes!
1,423 Questions
661 Questions
607 Questions
562 Questions
482 Questions