...1989 Toyota Pickup 2wd w/manual transmission. I suspect that the hydraulic lines from the clutch master cylinder is leaking where it goes into the transmission. Where is this located? engine side at ...
Question about 1989 Land Cruiser
...1989 HJ60 landcruiser[toyota] 25000 klms since new brake system. Bled brakes 4 times pedal will depress to half way and pump up full on 1 to 2 pumps. the peddle when pmped up is around 3/4 of the way ...
...I have ok pedal but not stiff as it should be. also the truck won't roll freely and i think this has something to do with the breaks also. check the master cylinder and the porporsioning
...master cylinder for oil. If oil got into the system then all the rubber parts have expanded and caused this condition. The other cause is that something is blocking the compensation vent hole inside ...
...hydraulic cylinder and my clutch doesnt work properly 1989 pu where is the resevore to refill fluid under the hood,next to the brake master cylinder.on some models the 'lid'is held on with a
1989 Toyota sedan, and have to I have an older 1989 Toyota sedan, and have to press the clutch right to the floor to engage any gear. Does this mean a new gear box or is there another problem? Can you
Question about 1989 Pickup SR5
1989 Toyota SR5 We changed brake lines and rotors and drove ok for about a month. now the fluid is not recycling through the system. does not appear to be leaking- though Make sure the master cylinder
1989 toyota pickup shifting problem i pressed my clutch in and i heard a pop i changes my clutch master cylinder i changed the slave cylinder i changed my cluth and its still stuck in N it ran fine ...
Question about 1989 Pickup SR5
Toyota Corolla 1300 2e 1989..... I changed clutch master and slave cylinders and the pipes my car refuses now to hold clutch compression... Pls assist Insure you have properly bled the air from system
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions
