When i plug it in to the back of the computer it come on for 2 secones then go black

Check your settings on the CMOS... try using RGB + Analog as your display

Most common failures in the LCD monitors are bad capacitors (bulging top/seal or leaking) in the power supply, failed inverter circuits (blown fuse, shorted transistors, shorted/open transformers), bad lamps (poor solder connections or worn out lamps). You will need to open it up and inspect the inside, see example of failed ACER monitors to get some ideas what to look for: http://s807.photobucket.com/home/budm/allalbums
Post back what you see inside so we can guide you further and it will help out other people in the future also.
http://www.badcaps.net
http://en.wikipedia.org/wiki/Capacitor_plague

try to take the battery out for about 30 secons and then put it back in and see of that resets the system to bring it back to life

Check for bad caps in the power supply, worst case will be bad backlight lamps.

on the right hand side ther are 3 wires 2 black and 1 white turn key off swap the white and black ... turn key on for 45 secons then back off swap back .. turn key on

When the screen is black, try pressing Ctrl + Alt + Del; a soft reset should kick it back into gear. Did the laptop shut down unexpectedly due to power loss/overheating/etc..?

Ok, if your mouse is throwing your cruiser around and it is lagging this may mean that you have too much interference between the mouse and the receiver plugged into your computer, first check to make sure that you do not have to many objects between the mouse and the computer and if your mouse uses batteries then you need some new ones in their. If that still doesn't work try unplugging the receiver from the computer and a few seconeds and plug it back in this also works sometimes.

U UNPLUGGED THE SECON CONTROLLER SO PLUG IT BACK IN DUH

try to adjust the setting of your video and refresh rate