My refrigerator is beeping and has high temperature both (freezer 30F and refrig. 58F). I try to set to default, but it didn't change.

I would set the fridge in the middle, check it in a couple hours and see what the temperature is. I like my fridge too be at 36 degrees. Adjust the temperature control as needed to get the temperature to what you like. Do the same with the freezer, I like my freezer to be around 28 degrees. My big freezer I keep at about 10 degrees.

George makes a good point but I'd like to add that there is generally a fan that blows the air between the freezer into the fridge area. If there is no obstruction, the fan most likely needs to be replaced. On a few models this can be done with a little patience and a screw driver and the fan part. Check with a Sears Parts distribution store avaiable around the country for the part if the model is carried by Sears. If not, Google the fridge make and model number with Freezer Fan Replacement.

Hello - Could it possibly be HI? Typically error code HI indicates that the unit has detected high temperature in freezer. Try setting the unit to a lower setting. Generally the factory setting is 0 for the freezer temperature and 37 for the fresh food temperature.

probably going to default setting check manual are you trying to set to low or have quick freeze on or auto eco etc

Hi,

There can be many reasons why your refrigerator is freezing your food. To see what could be happening and to figure out how to possibly fix your problem. Take a look at this tip which contains many of the causes and solutions to fix the problems.

Refrigerator is Too Cold and Freezing Food

heatman101

Your most likely cause is the $170 control board. It is the only thing that I know of that can change the temperature automatically. Please rate this post.

Set both dials in the middle.

If you have a nearly full freezer, add 1 dial unit.
If you have a nearly full refrigerator, add 1 dial unit.

If your freezer is less than half full, step down 1 dial unit
Refrigerator should not be less than mid-point on dial (it gets open more often).

This is a good starting point, adjust in a month or so.

thermostat problem replace that if you know how to do that or call a technician who will help you

At the refrig controls , the freezer control , controls how much air goes into the refrigerator section . Open the refrig door , and up at the top left , put your hand over the damper (air vent) . Turn the freezer control from high to low , and feel the difference in the air flow . If you turn your freezer control to a lower setting , less cold air will enter the refrig . Think of it as : the freezer control adjusts the temperature , and the refrig control , tells how long to run the compressor . In actuality , this is how it works . However , with the dial (refrigerator thermostat) in the off position and refrig still running , this indicates a bad thermostat . Pt # 2198202 .

You probably have a defective thermostat or sensor for reading the temperature.