Question about Frigidaire FAC126P1 wall/window Air Conditioner

1 Answer

The fan is not working in my air conditioner. How do I remedy this problem? Thank You

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Expert
  • 3,773 Answers

Check capacitor and burned wires if it has one if not
It will probably have to be replaced.
Have a service man to check before you replace it.
If this was helpful please rate me.
Leo Ponder Appliance-Tyler,Texas

Posted on Aug 06, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Code es error

Hi Kirby, thank you for allowing me to assist you!

Error code ES and P1 are commonly referred to a sensor failure. Because it is a smaller appliance, repairs are often more costly than the actual unit replacement. Is your appliance still in warranty? If so, you might want to reach out directly to the manufacturer to determine the coverage on your air conditioner and the procedures to any potential remedy in that regard.

Best of luck!

Sep 12, 2013 | Frigidaire FAP094P1Z Portable Air...

1 Answer

Air conditioner is blowing hot air; fun blade not working

dear sir

if fan motor is not working that why your airconditioner is not getting cold. please try to test fan motor by electric tester check continuity on fan motor wire one bye one. if there is all wire have continuity with each other then it,s mean fan motor is ok and problem in other device . if you can do by yourself then try if not then take help to a technician.

hope answer the question
thank you
please vote!

Oct 03, 2010 | Carrier 38CKC036 Air Conditioner

1 Answer

How to keep the fan speed on low at all times on the Soleus Air MAC-10K? Every time we adjust it to low after about 10 minutes it automatically changes fan speed to high and it does not go back to low...

dear sir

i think your air conditioner,s micro controller system is not working well, that why this problem is coming .please contact to your product dealer for replace it .

hope answer the question
thank you
please vote!

Sep 29, 2010 | Soleus MAC-10K Air Conditioner

1 Answer

I have taken case off of unit and it blows cold air but the fan is rubbing on frame

Usually caused by aging rubber fan motor mounts, worn fan motor bearings, the fan blade assembly slipping on the fan motor shaft, or a warped chassis. You can replace or eliminate rubber fan mounts cheaply. A slipped fan blade tends to need a simple position adjustment and tightening or replacement of the lock screw. Worn fan motor bearing or warped chassis are not so cheap to remedy, and since it's a lot easier and quicker to grind down the fan shroud until they no longer make contact, that's the route I tend to take.

Aug 14, 2010 | Haier HWR08XC3 8K RAC Elec w/ remote Air...

1 Answer

Fan comes on but blows warm air

So you had a guy charge it and he did not make sure it worked??? Call the shister back and make him fix it right!!!

Here is a tip about trouble shooting your air conditioner...

Air Conditioner Trouble -Review the Possibilities


Jul 21, 2010 | Intertherm P3RA-048K Air Conditioner

3 Answers

My air conditioner is blowing hot air. The outside fan in not wo

sounds like a contactor problem. this is the switch that kicks the outside fan amd compressor on. If the inside fan runs it will be on the outside.

Jul 08, 2010 | Whirlwind FH-778 Air Conditioner

1 Answer

Fan not working on outside AC unit

The buzzing noise is probably the fan motor. Is the compressor running? First make sure that there are no tripped breakers. After that kill the power and check the capacitor with a multimeter. If that checks good then check the fan motor windings with the multimeter. Let me know if you have any questions.

May 26, 2010 | Intertherm P3RA-060K Air Conditioner

1 Answer


This is a condition called Dirty Socks Syndrome air cleaners and dehumidify usually fix the problem also adding a uv light to the duct can remedy the problem the light is probally the cheapest solution

Dec 04, 2008 | LG LS-K1830CL Cool Mini Split Air...

1 Answer

Blows room temperature air

Welcome to fixya.
I'm Huuum and happy to assist you

The air conditioning
unit works, but does
not cool the room

• window open
• there are heat sources in the room (burner,
lamp, etc)
• the exhaust hose is detached
• air filters clogged
• Inadequate size of the room (too large)
• close the window
• eliminate the heat source
• connect the exhaust hose
• clean or replace the filters
If all this dose not remedy the problem then you need to see service!

Please remember to leave a rating before you go!
Thank you

Jul 13, 2008 | DeLonghi Pinguino PACL90 Portable Air...

Not finding what you are looking for?
Frigidaire FAC126P1 wall/window Air Conditioner Logo

Related Topics:

39 people viewed this question

Ask a Question

Usually answered in minutes!

Top Frigidaire Heating & Cooling Experts

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Bill Long

Level 3 Expert

588 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Are you a Frigidaire Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides