Km4050 cfb31 - Kyocera Office Equipment & Supplies

The only solution is to clean the discharge lamp of the drum housing and also making sure that drum terminals are cleaned well

Nam S?n Laser l? nh? ph?n ph?i ??c quy?n c?a nhi?u th??ng hi?u m?y laser n?i ti?ng tr?n th? gi?i nh? Co M?ch, GCC, Epilog, Trumpf

Paper jam

hello guys i have ever also being challenged by that error code cfb31 but its simple to clear that error in way that when the DIMM is faulty it can cause it but any way champ try to-get anew good firmware or a new DIMM believe me not that error code will disappear if you take my advice

Hello,
the error is a system error if the following error code is displayed. When an error has occurred, clear the error by turning the main power switch off then on.
These error type should be reseted by restarting the machine
CF1XX, CF2XX, CF3XX, CF4XX, CF5XX, CF6XX, CF7XX, CFAXX, CFBXX, 0xFBXX

Best regards,
Marius

theres a sercive manual on this page as pdf format,hope it helps

Error Codes Kyocera Mita KM5050 Code C4200

You may have a bad controller board too. If the copier is under contract or warranty, have the vendor diagnose or replace these components if necessary

i have the problem cfb31 in machine kyocera km 4050/5050

hello,
This error has to connect the connector (red, green, white, black, black) in the wrong place in panel. yc1 - yc9

km4050 cood cf26f