Kv-36hs20 7 yr old, starting to bleed(ghost) colors on lettering. green on black. darker blue on blue. these bleeds are to the right.

you can remove front speaker cover,then remove screws from board,you will see 6 controls,3 are focas(all in a row)3 are screen controls.sets are for red green and blue,blue should be to the rite,turn blue controls until picture gets better.they are labeled screen and focas

It is an old model of 1995 and I'm sure it has problem of leaky electrolytic capacitors. You need to replace all electrolytic capacitors in this camcorder.

Color bleeding document from HP:
http://h10025.www1.hp.com/ewfrf/wc/document?lc=en&dlc=en&cc=us&product=306892&docname=bpu02176#bpu02176_doc

I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_8b8c2cd6ce148309

You will need to bleed all four corners, starting at the right rear, then left rear, then right front, then left front. Your bleed procedure always goes from the wheel farthest from the master cylinder, to the closest. By bleeding only the rear brakes, you've gotten air out back there, but not necessarily any air that might have moved farther forward. Bleed your rears again, and then move forward to bleed the fronts, and see if that helps.

This may be some bad capacitors on the video output board or in along the processing path of the video amp sections. It is also possible that the CRT is causing this.

The set should be properly checked to determine the fault.


Jerry G.

Hi,

Service the LCD Panels and then try.

Viren

Remove the toner cartridge and drum assembly together. Gently rock the assembly from end to end, as when installing a new toner cartridge. Then put the assembly back in place. This procedure worked for me. I'm guessing that I must have laid the toner and/or drum on its side, or perhaps upside down, when I was replacing the drum, and this was responsible for the problem.

did you just replace your lamp? your balance is probably off.

Sounds like the same problem i had recently, Take the front off, (its safe so your ok) You will see the 3 lenses which are ajustable, Just keep adjusting 1mm at a time until it solves this, Took me about 45 mins to get it perfect, Persist and you will get there!! Hope this helps

this sympton is characterized by the presence of red, cyan, green, magenta, blue or yellow colour in a supposedly plain white raster. proper colour reproduction cannot be expected if the raster is coloured. this symptom is caused by a poor white balance adjustment of by a trouble in the CRT, colour amplifier, color demodulation or colour output circuits. if the raster has a tint of red or cyan, check the R-Y output circuits and the first grid, second grid and cathode circuits of the red electron gun. but if you dont know anything about this, just bring it to a qualified service technician. good luck!