How do you get the nightlight to work? The electricians that installed the Whisper Fit took all the printed info with them!

you will need to have 3 conductor/gnd wire pulled for switch box to fan/light. install a tandem single gang twitch. this will require an electrician.

no help for diy electricians
get in an electrician and have the job done safely

Read the instructions.
My new replacement bags have the instructions right one one side of the bag itself. or if you have the book read the instructions.
Mine is a Kenmore Whisper tone but not 300 so I won't pass on my instructions but my bags fit different Whisper tone Vacs.

Well a

Can you provide more info. There isn't enough to help at this point.

https://motorola-global-portal.custhelp.com/app/answers/prod_answer_detail/a_id/95179 to look at the quick start guide.

Mark
Motorola Support

you can get guides online for error codes/ fault codes, wiring diagrams, schematic diagrams, torque specs, engine info, switches functioning, assemble, disassembly, complete refurbish, repair, installation every single thing is covered
within seconds u can get the access and it's totally illustrative complete
I know these websites

Someone called Crane company to find out that there is NO night light. The frog design just doesnt have one. They said that the manual is a generic one for all the humidifiers.

Hi,
In all probability, the short took out the relay on the control board and the control board will need to be replaced.

I hope that helps.

This is a problem with the control panel assembly, which we repair nationwide for $39.95. This is most often caused by the filaments shorting when the bulb blows, or by not disconnecting the microwave from the power line when removing or installing a bulb. Full information on our service is available at our site, which is linked at our listing here on FixYa: http://tinyurl.com/yzjozk