Fatal Error 6203

Follow these steps:

1. Open printer access door
2. Turn off power,wait for 30-40 seconds,then turn on power
3. Now turn on printer and it will show 'access door open'
4. Close printer access door.

I hope this error 6203 will not occur then!

Cheers!!!

Error code "6203" can be resolved as follows:
First, you need to open the access door of the printer and disconnect the power adapter from it.
You then need to wait for at least 30 seconds for the printer to get reset.
As a next step, you can connect the power adapter back to the printer.
You can turn on the printer, if required. Once the printer gets powered up, a message "Printer access door open" gets displayed.
Once this message gets popped up you can close the access door of the printer. get more help for Printer Error Code 6203
Hope this helps you.

Error code "6203" can be resolved as follows:
First, you need to open the access door of the printer and disconnect the power adapter from it.
You then need to wait for at least 30 seconds for the printer to get reset.
As a next step, you can connect the power adapter back to the printer.
You can turn on the printer, if required. Once the printer gets powered up, a message "Printer access door open" gets displayed.
Once this message gets popped up you can close the access door of the printer.
http://www.fixya.com/support/t5951196-kodak_easy_share_5300_printer

printer needs to be replaced

call kodak at 18004216699

There can be plenty of reasons behind Error code "6203". These error codes often get displayed during printer installation. It is often seen that 'Error code "6203" gets displayed mostly when the printed calibrated sheet is put into the tray for scanning purpose and push button is pressed.
http://www.fixya.com/support/t5951196-kodak_easy_share_5300_printer

If that's the error code your computer is showing, it's not on their list. You need to give the error code shown on the printer display.

Hardware error

Error Code 3501
Error Code 6203
Error Code 6203
Error Code 3501

turn off the printer
unplug the power chord at the back of the printer
wait for 5-10 sec.
replug power chord
turn on the printer

not sure, but try to turn printer on and off, remove and replace printehead, to see if this will work,

Kodak website has instruction manual that you can download. It tells you how to remove and reinstall the printhead. Basically you remove the ink tanks first by pressing the lever at the front and angling them upward. Once both the inks are out you press on a lever on the upper left side of the printhead (the black thing the ink cartridges were resting in). That lets the printhead come out. Now the tricky part is to get it back in. You put the printhead back in until it clicks and then gently put in the ink cartridges. I say gently because if you press too hard you may cause the printhead to become loose which means you will have to start over again. Everything "clicks" when it is in correctly.