Pioneer djm 600 mixer worn plate need new one

The fader pot will need to be replaced. There is no way to glue or repair the tab.

Chances are the actual fader is faulty.
Can you solder? - look here :-
http://cgi.ebay.co.uk/PIONEER-REPLACEMENT-FADER-DJM500-DJM600-DJM-800-300-etc-/260401328795?cmd=ViewItem&pt=UK_Mixers&hash=item3ca120f29b

If not look here :-
http://cgi.ebay.co.uk/PIONEER-DJM-600-DJM-600-CHANNEL-3-FADER-SLIDER-DWG1523-/260494741288?cmd=ViewItem&pt=UK_Mixers&hash=item3ca6b24f28

I have the same problem, One day I open the djm-600 for replace the jack whole (easy), then of this when i close the mixer my pioneer died, but when I push the power button I can listen a little sound like ¿voltage running? Please Help !!!

Thanks

pd: sorry for my bad english

There is a master gain volume control on the rear of the mixer, where you connect everything. Make sure it's not down.

If it's fine, then maybe them being outside caused an issue. How cold is cold? If your talking freezing, then maybe there is some issues with the solder on the pc boards. You'll have to take it to a service center at this point.

I would say, try connecting a CD player to all the channels, and try from there. If it's still the same, then you need professional help.

- OPTiC
DJ Equipment Repair & Service
A DJ Pro Audio Co.

start with connections and try to clean fader with lubricant contact cleaner from radio shack or any electronics store.

check your input (cables and device)for bad or short circuit cable-bad plug--connection between inner conductor and shield. of the cable(test with new one)------you can disconnect inputs one by one until you find the bad one.and change it.

connect your gemini phono out to -------- pioneer phono in.

send out from mixer---------to pioneer in---------from pioneer out-----to return in mixer.

Go to http://www.pioneerelectronics.com/PUSA/ to find an authorised Pioneer dealer near your location. They will be able to get the part you need.

the rcas need to be resoldered