Mita all copies have clean, thin, black streaks

hi there . sevsral rssons cause that . first you have to clean the toner tank which located down of the drum unit if you dont have the experiance you have to call your technical to do it for you .
another propable reason the drum unit need to clean and you will get it out any way in the first step

Try using a small soft brush to brush it off while using a good hepa filter vacuum to remove the toner at the same time. Wear a good breathing mask to protect your lungs!

Go through the maintenance procedures in your manual. All cleaning should be done which probably includes roller cleaning but you should run it through all the procedures.

Clean the optical parts (lens,mirrors),and the poligon motor mirrors.

If you send a print job or print a report from the copier and there is no streaks then the problem is most likely the thin **** glass to the left of the large glass. It just needs to be claened.

If the streaks are happening when printing and copying then the problem is most likely your drum unit (MK-410) or possibly the fixing unit (FU-410), the fixing unit is the one that gets hot.

As the drum gets old it can cause print/copy issues and the cleaning blade that cleans the drum gets to the point it doesn't clean the drum properly causing streaks.

The heat roller has a teflon coating on it and as the roller gets older the teflon starts to come off and can effect prints/copies.

The drum unit should be replaced every 150,000 pages and the fixing unit every 300,000 pages on the KM-2050.

I hope this is helpful,
Shawn

this sounds like either fuser wera or drum wear if you open the side door and look at the fuser section this is at the top and you should be able to see two rollers on orange one black look were the guide fingers are you may see wear lines on the surface usually looks like alloy which is under the coating.. if not seen here it could be the drum worn..if the lines are from copying check the glass plate both thin glass and the main glass. if you look under the glass at the mirrors you may see some dirt or dust.. this can be cleaned

Hello, Glen.

Here's a link for a cleaning blade:

http://74.125.113.132/search?q=cache:UtkZ_0m7QVwJ:www21.shopping.com/xPO-DRUM-Cleaning-Blade-73918030+Mita+DC-1435+%22maintenance+kit%22&cd=1&hl=en&ct=clnk&gl=us

And, here's a link for Kyocera-Mita maintenance kits, but the specific model is not listed. You'll need to contact them at 877.813.7201 or email [email protected] to see if there is a kit for your specific model:

http://www.worldclassink.com/Cheap-Kyocera-Mita-Maintenance-Kit-m43-ift6.html

Hope this helps.

check the rectangular **** glas and table for any white out or particles... clean thoroughly... make copies... clean again... make copies... if same issue... then replace drum... but in most cases its the optics... which I advised you to clean thats causing the issue... if the issue occurs when you print an internal report then its definitely drum... if reports are clear... there is something on the glass... or on the part above it... even a little bit of black toner or ink or whiteout anywhere out there can cause a line

I’m happy to assist further over the phone at https://www.6ya.com/expert/norman_d2fa496dce30c65d

Most likely it is a bad drum cleaning blade. It will need to be replaced. This machine is old...good luck.

Check Drum from scratches,check cleaning blade.Also check Heat roller.