RCA P52927 volumn control

you can buy a universal remote for 1 dollar.. option 1 however if you are using componelt input as in RGB then you have no control over your colors

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/tony_a41fa0b801734e2f

Sounds like a shorted audio IC or bad connection in the limiter circuit.

Take the batteries out of the remote control, then apply a piece of black tape over the IR sensor, Unplug the power, wait a few minutes, now power the unit back up, does the unit still have the same volume high symptom? If so, remove the tape and see if the unit responds to any other commands(other than volume) from the front panel. If it responds to the panel controls, the processor is most likely good. very seldom is the IR transistor bad, if it is no input command will work.

Fix the button.

click start control panel sounds and audio devices you can adjust the volume there also select speaker volume you can change your settings there you can also tick in the box place icon in taskbar
hope this helps

You can adjust the volume by holding down the 'Fn' key (bottom row, second from the left) and pressing Page Up and Down keys (on the far right) to turn the volume up and down respectively.

Hi
most phones only allow you to increase/decrease volume of earpiece whilst your in a call. Whilst making a call the buttons on side of phone (up/down) should allow you to adjust volume. Sometimes these buttons also allow adjustment of ringer volume when not in a call. Hope that helps?

If your volume controls are not working you may need to reinstall or update your drivers. These drivers are available via the dell website just use this link.
http://support.dell.com/support/downloads/index.aspx?c=us&l=en&s=gen

if there is a menu button or something like it look for avc auto volume control set to 0

Need adjust coil sound ( little metal beside Big IC or between tuner and IC). Turn a little right and left ( be sure leave same position) don't play with this coil too much, will mess up video signal , some times tuner need be re solder. I hope this will help you Thank you!!!