How is clear F2 - Sharp AR-M160 Black and White Copier

Sharp ARM316 - Error Code: F2-02

PrintCopy .info https://printcopy.info > model=ARM316 > code=F2-02
Code: F2-02; Description: Toner supply failure. The value judged from the actual toner supply hysteresis differs greatly from the toner sensor value.
Missing: photocopier. ‎' Must include: photocopier.

• 
  

  Sharp ARM355 - Error Code: F2-02

  https://printcopy.info > brand=Sharp > code=F2-02
  Code: F2-02; Description: Toner supply abnormality. Toner control sensor output value becomes under-toner too earlier. Causes: Connector harness trouble ...
  
  Generic video
  
  

Error Codes > Sharp > AR5516 > Code F2 02 - Printcopy.info

https://printcopy.info > brand=Sharp > model=AR5516
Code: F2 02; Description: Toner supply abnormality Detail When toner near end is detected with the toner supply time of 50% or less.

Go to the Manufacturers web site and view FAQ's & or e-mail them.

I’m happy to help further over the phone at https://www.6ya.com/expert/wynn_5ba0205233ebfc15

according the manual F2-04 means drum data read problem,may be it can be reset.
1, power on,
2, press "clear","interupt", "0", "interupt"
3, press 14 prss start
4, press clear

Hello,

The F2 error code means that the oven over heated by at least 100 degrees and the oven temp.sensor needs to be replaced.

On the self clean cycle the oven temp can easily reach over 600 dergees and therefore the sensor thinks it got too hot. If you have not already done so the F2 can be cleared by pushing the CLEAR/OFF button on the control...if the F2 error code reappears the sensor has became defective and it would need to be replaced.


GENE

Hi there,

Well F2 error codeis on a variety of Sharp copiers, the F2 error code would normally be accompanied by a sub code that indicates the fault, You may please check out the following -

• F2 with sub code 00 - Toner Sensor problem, ID pattern reading error;
• F2 with sub code 02 - Toner Motor problem, check toner dispenser motor;
• F2 with sub code 31 - Image Density error, Check the light level or the drum surface reflectivity;
• F2 with sub code 32 - Drum Mark sensor, missing/dislocated mark or sensor faulty. Sensor cannot scan mark properly;
• F2 with sub code 33 - grid voltage wrong, either too high or too low;
• F2 with sub code 35 - grid voltage correction will not work during simulation;
• F2 with sub code 37 - drum mark sensor adjustment required.

You may post further comments for more help or information......

Good Luck!!

Thanks for using FixYa!!

F2 means wrong cartridge installed, could be a bad cartridge. H4 is a low fuser temp error. try resetting by pressing "#","interrupt","C","interrupt. then press"1","4","start". then turn off/on and see if it clears. if not you will need a tech.

Clean image density sensor on the drum unit and make sure the blade is cleaning the drum.

according the manual F2-04 means drum data read problem,may be it can be reset why don't give a try;
1, power on,
2, press "clear","interupt", "0", "interupt"
3, press 14 prss start
4, press clear

Need to know what machine it is you have